Polyimide/Epoxy resin-molybdenum disulfide bonded solid lubricant coatings (denoted as PI/EP-MoS₂) were prepared. The influence of polyfluo-wax (denoted as PFW) on the microhardness and friction and wear behavior of as-prepared PI/EP-MoS₂ lubricant coating was measured using a microhardness tester and a reciprocating ball-on-disc tribometer, respectively. The worn surfaces of the lubricant coatings were observed with a scanning electron microscope, and their wear rate was determined with a Micro XAM surface mapping microscope. Moreover, the transfer films formed on the counterpart steel ball surfaces were analyzed by X-ray photoelectron spectroscopy. Results indicate that the incorporation of a proper content of PFW filler is effective at improving the antifriction performance of the PI/EP-MoS₂ lubricant coating while maintaining better wear resistance. Moreover, the friction coefficient of the lubricant coating decreases with increasing content of PFW from 2 to 10%, and the one with a filler content over 6% PFW has a steady friction coefficient of 0.07. The improvement in the antifriction performance of the lubricant coating with the incorporation of the PFW filler is attributed to the excellent lubricity of homogeneously distributed PFW.