Design and Qualification of Joints for ITER Magnet Busbar System
文献类型：期刊论文
| 作者 | Ilyin, Yury1; Gung, Chen-Yu1; Wen, Xinjie2; Beemsterboer, Cornelis1; Farek, Jaromir1; Chen, Liu2; Ding, Kaizhong2 ; Lu, Kun2; Man, Su1; Chen, Yonghua1
|
| 刊名 | IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY
 |
| 出版日期 | 2016-06-01 |
| 卷号 | 26期号:4页码:4800905 |
| 关键词 | Indium Iter Magnets Joint Magnet Feeders |
| DOI | 10.1109/TASC.2016.2515984 |
| 文献子类 | Article |
| 英文摘要 | The joints connecting the ITER magnet busbars and coils utilize the twin-box "shaking hands" concept: inside a helium leak tight box, a bare cable is pressed in an indium-tinned copper base. To form the joint, two boxes are tightly compressed against each other on the copper side with a layer of indium in between. This concept was chosen to address the different requirements of the joints: to provide low electrical resistance without degradation and need of maintenance during ITER lifecycle, to sustain cyclic electromagnetic and pressure loads, to be easily dismountable in case of failure, to be tolerant to manufacturing and assembly misalignments, to provide low coolant flow impedance, and to limit ac losses and at the same time to facilitate current redistribution in the busbars. This paper presents the design; the key results of the electromagnetic, thermal, and stress analysis; and the major manufacturing and qualification steps. The latter includes cryogenic fatigue test of the joint welds and joint resistance measurements. |
| WOS研究方向 | Engineering ; Physics |
| 语种 | 英语 |
| WOS记录号 | WOS:000370946200001 |
| 源URL | [http://ir.hfcas.ac.cn:8080/handle/334002/21715]  |
| 专题 | 合肥物质科学研究院_中科院等离子体物理研究所 |
| 作者单位 | 1.ITER Org, F-13067 St Paul Les Durance, France 2.Chinese Acad Sci ASIPP, Inst Plasma Phys, Hefei 230031, Peoples R China |
| 推荐引用方式 GB/T 7714 | Ilyin, Yury,Gung, Chen-Yu,Wen, Xinjie,et al. Design and Qualification of Joints for ITER Magnet Busbar System[J]. IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY,2016,26(4):4800905. |
| APA | Ilyin, Yury.,Gung, Chen-Yu.,Wen, Xinjie.,Beemsterboer, Cornelis.,Farek, Jaromir.,...&Mitchell, Neil.(2016).Design and Qualification of Joints for ITER Magnet Busbar System.IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY,26(4),4800905. |
| MLA | Ilyin, Yury,et al."Design and Qualification of Joints for ITER Magnet Busbar System".IEEE TRANSACTIONS ON APPLIED SUPERCONDUCTIVITY 26.4(2016):4800905. |
入库方式： OAI收割
来源：合肥物质科学研究院
浏览0
下载0
收藏0
其他版本
除非特别说明，本系统中所有内容都受版权保护，并保留所有权利。