Comparison and discussion on fragmentation behavior of soft rock in multi-indentation tests by a single TBM disc cutter
文献类型：会议论文
| 作者 | Liu, Quansheng1; Pan, Yucong1; Liu, Jianping1; Kong, Xiaoxuan2; Shi, Kai3 |
| 出版日期 | 2016 |
| 会议日期 | 2015 |
| 会议地点 | Singapore, SINGAPORE |
| 关键词 | Tunnel boring machine (TBM) Disc cutter Penetration depth Rock fragmentation Indentation test |
| 卷号 | 57 |
| DOI | 10.1016/j.tust.2016.02.021 |
| 页码 | 151-161 |
| 英文摘要 | This paper is to investigate the mechanical responses and failure characteristics of soft rock in multi indentation tests by a single TBM constant cross section (CCS) disc cutter. Different pre-set penetration depths and totally three cycles of indentation processes were employed in the repeated indentation tests conducted on the cubic cement mortar specimens. The load-penetration depth curve, penetration load, peak-load penetration depth, rock breakage work and compacted zone depth for the three indentation processes were analyzed. The strength and deformation properties and failure behavior of soft rock under different indentation conditions were revealed. The rock breakage behavior after several indentation processes still presents brittle failure characteristic with small pre-set penetration depths, but the specimens with large pre-set penetration depths appear obvious plastic failure mode. Approximately equal leap loads are obtained from both the intact specimen in direct indentation failure test and the weakened specimens after several indentation processes with different pre-set penetration depths, but the pealcload penetration depths for specimens with different pre-set penetration depths are varying. Curves of the cumulative penetration depth and cumulative rock breakage work both reach the corresponding peak values for one certain pre-set penetration depth. Along with this most unfavourable pre-set penetration depth, rock breakage efficiency is the lowest and energy consumption is the highest (C) 2016 Published by Elsevier Ltd. |
| 会议录 | TUNNELLING AND UNDERGROUND SPACE TECHNOLOGY
 |
| 会议录出版者 | PERGAMON-ELSEVIER SCIENCE LTD |
| 会议录出版地 | OXFORD |
| 语种 | 英语 |
| WOS研究方向 | Construction & Building Technology ; Engineering |
| WOS记录号 | WOS:000378184100018 |
| 源URL | [http://119.78.100.198/handle/2S6PX9GI/4911]  |
| 专题 | 岩土力学所知识全产出_会议论文 国家重点实验室知识产出_会议论文 |
| 作者单位 | 1.Chinese Acad Sci, State Key Lab Geomech & Geotech Engn, Inst Rock & Soil Mech ; 2.Wuhan Univ, Key Lab Safety Geotech & Struct Engn Hubei Prov ; 3.Mkt Ctr Country Garden Holdings Co Ltd |
| 推荐引用方式 GB/T 7714 | Liu, Quansheng,Pan, Yucong,Liu, Jianping,et al. Comparison and discussion on fragmentation behavior of soft rock in multi-indentation tests by a single TBM disc cutter[C]. 见:. Singapore, SINGAPORE. 2015. |
入库方式： OAI收割
来源：武汉岩土力学研究所
浏览0
下载0
收藏0
其他版本
除非特别说明，本系统中所有内容都受版权保护，并保留所有权利。