(Ti,Al)N Film On Normalized T8 Carbon Tool Steel Prepared By Pulsed High Energy Density Plasma Technique
文献类型：期刊论文
| 作者 | Liu YF ; Deng FP; Han JM; Xu XY; Yang SZ; Liu XB(刘秀波)
|
| 刊名 | Chinese Physics Letters
 |
| 出版日期 | 2007 |
| 页码 | 3469-3472 |
| 通讯作者邮箱 | yfliu@bjtu.edu.cn |
| 关键词 | Chemical-Vapor-Deposition Ticl4/Alcl3/N-2/H-2/Ar Gas-Mixture (Ti1-Xalx)N Coatings Nitride Films Behavior |
| ISSN号 | 0256-307X |
| 通讯作者 | Liu, YF (reprint author), Beijing Jiatong Univ, Inst Mat Sci & Engn, Beijing 100044, Peoples R China. |
| 中文摘要 | Under optimized operating parameters, a hard and wear resistant ( Ti,Al)N film is prepared on a normalized T8 carbon tool steel substrate by using pulsed high energy density plasma technique. Microstructure and composition of the film are analysed by x-ray diffraction, x-ray photoelectron spectroscopy, Auger electron spectroscopy and scanning electron microscopy. Hardness profile and tribological properties of the film are tested with nano-indenter and ring-on-ring wear tester, respectively. The tested results show that the microstructure of the film is dense and uniform and is mainly composed of ( Ti,Al)N and AlN hard phases. A wide transition interface exists between the film and the normalized T8 carbon tool steel substrate. Thickness of the film is about 1000 nm and mean hardness value of the film is about 26GPa. Under dry sliding wear test conditions, relative wear resistance of the ( Ti,Al)N film is approximately 9 times higher than that of the hardened T8 carbon tool steel reference sample. Meanwhile, the ( Ti,Al)N film has low and stable friction coefficient compared with the hardened T8 carbon tool steel reference sample. |
| 类目[WOS] | Physics, Multidisciplinary |
| 研究领域[WOS] | Physics |
| 关键词[WOS] | CHEMICAL-VAPOR-DEPOSITION ; TICL4/ALCL3/N-2/H-2/AR GAS-MIXTURE ; (TI1-XALX)N COATINGS ; NITRIDE FILMS ; BEHAVIOR |
| 收录类别 | SCI |
| 语种 | 英语 |
| WOS记录号 | WOS:000251774200049 |
| 公开日期 | 2009-08-03 ; 2009-09-14 |
| 源URL | [http://dspace.imech.ac.cn/handle/311007/25512]  |
| 专题 | 力学研究所_力学所知识产出(1956-2008) |
| 推荐引用方式 GB/T 7714 | Liu YF,Deng FP,Han JM,et al. (Ti,Al)N Film On Normalized T8 Carbon Tool Steel Prepared By Pulsed High Energy Density Plasma Technique[J]. Chinese Physics Letters,2007:3469-3472. |
| APA | Liu YF,Deng FP,Han JM,Xu XY,Yang SZ,&刘秀波.(2007).(Ti,Al)N Film On Normalized T8 Carbon Tool Steel Prepared By Pulsed High Energy Density Plasma Technique.Chinese Physics Letters,3469-3472. |
| MLA | Liu YF,et al."(Ti,Al)N Film On Normalized T8 Carbon Tool Steel Prepared By Pulsed High Energy Density Plasma Technique".Chinese Physics Letters (2007):3469-3472. |
入库方式： OAI收割
来源：力学研究所
浏览0
下载0
收藏0
其他版本
除非特别说明，本系统中所有内容都受版权保护，并保留所有权利。