An open cnc system based on component technology
文献类型：期刊论文
| 作者 | Yu, Dong1; Hu, Yi1,2; Xu, Xun W.3; Huang, Yan1; Du, Shaohua1 |
| 刊名 | Ieee transactions on automation science and engineering
 |
| 出版日期 | 2009-04-01 |
| 卷号 | 6期号:2页码:302-310 |
| 关键词 | Cnc Component Fieldbus Interoperability Open architecture |
| ISSN号 | 1545-5955 |
| DOI | 10.1109/tase.2008.2009096 |
| 通讯作者 | Yu, dong(yudong@sict.ac.cn) |
| 英文摘要 | In a conventional cnc system, communications between the motion controller and the analogue servo driver usually take place in a unidirectional manner, i.e., from the controller to the driver. in order to increase the interoperability level between the motion controller and the driver, fieldbus is used in this research. the digital servo in a fieldbus-based system enables applications with all servoloops closed. functions that have been traditionally executed by the motion controller can now be shifted to the driver. in this research, the traditional cnc system has been redesigned based on the component technology. following the analysis of the architecture of a traditional cnc and the features of a fieldbus, component models have been developed for the motion controller and the driver. this fieldbus-based cnc system gives the much-needed interoperability between the motion controller and the driver. a comparative experiment based on a four-axis cnc system has been carried out to showcase the component model-based system. |
| WOS关键词 | STEP-NC ; INTELLIGENT |
| WOS研究方向 | Automation & Control Systems |
| WOS类目 | Automation & Control Systems |
| 语种 | 英语 |
| WOS记录号 | WOS:000265089600011 |
| 出版者 | IEEE-INST ELECTRICAL ELECTRONICS ENGINEERS INC |
| URI标识 | http://www.irgrid.ac.cn/handle/1471x/2399090 |
| 专题 | 中国科学院大学 |
| 通讯作者 | Yu, Dong |
| 作者单位 | 1.Chinese Acad Sci, Natl Engn Research Ctr High End CNC, Shenyang Inst Comp Technol, Shenyang, Liaoning, Peoples R China 2.Chinese Acad Sci, Grad Univ, Beijing, Peoples R China 3.Univ Auckland, Dept Mech Engn, Auckland 1, New Zealand |
| 推荐引用方式 GB/T 7714 | Yu, Dong,Hu, Yi,Xu, Xun W.,et al. An open cnc system based on component technology[J]. Ieee transactions on automation science and engineering,2009,6(2):302-310. |
| APA | Yu, Dong,Hu, Yi,Xu, Xun W.,Huang, Yan,&Du, Shaohua.(2009).An open cnc system based on component technology.Ieee transactions on automation science and engineering,6(2),302-310. |
| MLA | Yu, Dong,et al."An open cnc system based on component technology".Ieee transactions on automation science and engineering 6.2(2009):302-310. |
入库方式： iSwitch采集
来源：中国科学院大学
浏览0
下载0
收藏0
其他版本
除非特别说明，本系统中所有内容都受版权保护，并保留所有权利。