中国科学院机构知识库网格
Chinese Academy of Sciences Institutional Repositories Grid
Molecular weight dependence of phase structures and transitions of mesogen-jacketed liquid crystalline polymers based on 2-vinylterephthalic acids

文献类型:期刊论文

作者Ye, C; Zhang, HL; Huang, Y; Chen, EQ; Lu, YL; Shen, DY; Wan, XH; Shen, ZH; Cheng, SZD; Zhou, QF
刊名MACROMOLECULES
出版日期2004-09-21
卷号37期号:19页码:7188-7196
ISSN号0024-9297
DOI10.1021/ma049195b
英文摘要The phase structures and transition behaviors of a series of mesogen-jacketed liquid crystalline (LC) polymers, poly{2,5-bis[(4-methoxyphenyl)oxycarbonyl]styrenes} (PMPCS), with different molecular weights (MW) and narrow MW distributions were studied using differential scanning calorimetry, polarized light microscopy, Fourier transform infrared spectroscopy, and one- and two-dimensional wide-angle X-ray diffraction experiments. The LC phase structures of this series of PMPCS samples were found to be strongly MW dependent. The PMPCS samples were amorphous when the MW is lower than a critical MW of approximately 1.0 x 10(4) g/mol (an apparent MW, M-n(a), measured by gel permeation chromatography calibrated with the polystyrene standards). For the PMPCS samples with MWs higher than this critical value, the amorphous samples cast from solution developed into a LC phase above the glass transition temperature upon the first heating. In between 1.0 x 10(4) g/mol < Ma < 1.6 x 10(4) g/mol, a columnar nematic (Phi(N)) phase was stabilized. Above the M-n(a) = 1.6 x 10(4) g/mol, a hexatic columnar nematic (Phi(HN)) phase was observed. Within these two LC phases, the building blocks were cylindrical shaped, which was attributed to a cooperative assembly of the PMPCS backbone and its laterally attached mesogenic groups. The diameter of this cylindrical building block was in the vicinity of 1.6 nm as determined by WAXD experiments. All the LC phases were found to be stable up to the decomposition temperature of the PMPCS samples. The MW dependence of the LC phase diagram indicated that a critical aspect ratio (the ratio between the length and diameter of the cylinders) of the cylindrical building blocks must be required to stabilize these LC phases. On the basis of Flory's calculation, the critical aspect ratio should be 5.44, and this value corresponded to critical cylinder lengths of around 8-9 nm. Therefore, the lowest degree of polymerization which would stabilize the LC phases is similar to39-42 for this series of PMPCS samples.
语种英语
WOS记录号WOS:000223990200022
出版者AMER CHEMICAL SOC
源URL[http://ir.iccas.ac.cn/handle/121111/55363]  
专题中国科学院化学研究所
通讯作者Chen, EQ
作者单位1.Peking Univ, Coll Chem & Mol Engn, Dept Polymer Sci & Engn, Beijing 100871, Peoples R China
2.Chinese Acad Sci, Inst Chem, Ctr Mol Sci, State Key Lab Polymer Phys & Chem, Beijing 100080, Peoples R China
3.Univ Akron, Maurice Morton Inst, Akron, OH 44325 USA
4.Univ Akron, Dept Polymer Sci, Akron, OH 44325 USA
推荐引用方式
GB/T 7714
Ye, C,Zhang, HL,Huang, Y,et al. Molecular weight dependence of phase structures and transitions of mesogen-jacketed liquid crystalline polymers based on 2-vinylterephthalic acids[J]. MACROMOLECULES,2004,37(19):7188-7196.
APA Ye, C.,Zhang, HL.,Huang, Y.,Chen, EQ.,Lu, YL.,...&Zhou, QF.(2004).Molecular weight dependence of phase structures and transitions of mesogen-jacketed liquid crystalline polymers based on 2-vinylterephthalic acids.MACROMOLECULES,37(19),7188-7196.
MLA Ye, C,et al."Molecular weight dependence of phase structures and transitions of mesogen-jacketed liquid crystalline polymers based on 2-vinylterephthalic acids".MACROMOLECULES 37.19(2004):7188-7196.

入库方式: OAI收割

来源:化学研究所

浏览0
下载0
收藏0
其他版本

除非特别说明,本系统中所有内容都受版权保护,并保留所有权利。