An acceleration feed-forward control method based on fusion of model output and sensor data
文献类型：期刊论文
| 作者 | He, Qiunong1,2,3; Luo, Yong1,2,3; Mao, Yao1,2; Zhou, Xi1,2 |
| 刊名 | SENSORS AND ACTUATORS A-PHYSICAL
 |
| 出版日期 | 2018-12-01 |
| 卷号 | 284页码:186-193 |
| 关键词 | Tracking ability MEMS accelerometer Acceleration feed-forward Fusion of model and sensor |
| ISSN号 | 0924-4247 |
| DOI | 10.1016/j.sna.2018.10.031 |
| 文献子类 | J |
| 英文摘要 | In this paper, to enhance the tracking ability of a charge-coupled device (CCD) and micro-electro-mechanical-system (MEMS) accelerometer based low-cost tracking control system, an acceleration feed-forward control method based on fusion of model output and sensor data is proposed. To achieve the acceleration feed-forward control, the target acceleration is fed into the traditional acceleration-position dual closed-loop. Considering the CCD can only detect the line-of-sight (LOS) error of the target, the double integration of accelerometer measurement is regarded as the platform's position and is combined with the LOS error to build the target trajectory. The target acceleration is predicted by a Kalman filter, in which the combined target trajectory is used as the observed value. However, the basic acceleration feed-forward control method fails to improve the tracking ability at low frequencies due to inaccuracy of the accelerometer measurement caused by drift and noise. To solve this problem, we further propose to calculate an acceleration using the system acceleration model, and then use this calculated acceleration to fuse with the measured acceleration to obtain a new acceleration. The new acceleration, which is more accurate than the original measured acceleration in low frequency, is utilized to rebuild the target trajectory and predict the target acceleration again. Experimental results confirm the effectiveness of the proposed method. (C) 2018 Elsevier B.V. All rights reserved. |
| WOS关键词 | DELAY COMPENSATION ; TRACKING |
| 语种 | 英语 |
| WOS记录号 | WOS:000452569800024 |
| 源URL | [http://ir.ioe.ac.cn/handle/181551/9372]  |
| 专题 | 光电技术研究所_光电工程总体研究室（一室） |
| 作者单位 | 1.The Institute of Optics and Electronics, Chinese Academy of Science, Chengdu; 610209, China; 2.Key Laboratory of Optical Engineering, Chinese Academy of Science, Chengdu; 610209, China; 3.University of Chinese Academy of Science, Beijing; 100039, China |
| 推荐引用方式 GB/T 7714 | He, Qiunong,Luo, Yong,Mao, Yao,et al. An acceleration feed-forward control method based on fusion of model output and sensor data[J]. SENSORS AND ACTUATORS A-PHYSICAL,2018,284:186-193. |
| APA | He, Qiunong,Luo, Yong,Mao, Yao,&Zhou, Xi.(2018).An acceleration feed-forward control method based on fusion of model output and sensor data.SENSORS AND ACTUATORS A-PHYSICAL,284,186-193. |
| MLA | He, Qiunong,et al."An acceleration feed-forward control method based on fusion of model output and sensor data".SENSORS AND ACTUATORS A-PHYSICAL 284(2018):186-193. |
入库方式： OAI收割
来源：光电技术研究所
浏览0
下载0
收藏0
其他版本
除非特别说明，本系统中所有内容都受版权保护，并保留所有权利。