Development and application of W/Cu flat-type plasma facing components at ASIPP
文献类型:期刊论文
作者 | Li, Q.1; Zhao, S. X.2; Sun, Z. X.1; Xu, Y.1; Li, B.1; Wei, R.1; Wang, W. J.1; Qin, S. G.3; Shi, Y. L.3; Xie, C. Y.1 |
刊名 | PHYSICA SCRIPTA |
出版日期 | 2017-12-01 |
卷号 | T170页码:10 |
ISSN号 | 0031-8949 |
关键词 | plasma-facing components flat-type divertor tungsten EAST |
DOI | 10.1088/1402-4896/aa8921 |
通讯作者 | Luo, G-N(gnluo@ipp.ac.cn) |
英文摘要 | W/Cu flat-type plasma facing components (PFCs) were widely used in divertor of fusion device because of its advantages, such as low cost, light in weight and good machinability. However, it is very difficult to manufacture them due to the large mismatch between the thermo-mechanical properties of W and Cu. Institute of Plasma Physics, Chinese Academy of Sciences (ASIPP) has successfully developed W/Cu flat-type PFCs for EAST W/Cu divertor project by hot isostatic pressing (HIP) technology. This paper presents the development and application of W/Cu flattype PFCs at ASIPP. The optimized manufacturing process is to cast pure copper onto the rear side of W tiles at temperature of 1200 degrees C firstly, and then to HIP the W/Cu tiles onto CuCrZr heat sink at temperature of 600 degrees C, pressure of 150 MPa and duration of 3 h. W/Cu flat-type testing mock-up for EAST survived 1000 cycles at heat load of 5 MW m(-2) in high heat flux tests. And then ASIPP prepared two mock-ups for CEA's tungsten environment in steady-state tokamak (WEST) project. One mock-up withstood successfully 302 cycles of 20 MW m(-2), which are far beyond the design requirement. Since 2014, W/Cu flat-type PFCs were wildly used in EAST upper divertor as baffle and dome components which showed excellent performance in 2015 and 2016 campaigns. Given the success in EAST upper divertor, W/Cu flat-type concept is as well applied in the design of actively cooled Langmuir probes which will be mounted onto EAST divertor targets soon. |
收录类别 | SCI ; ISTP |
WOS关键词 | EAST ; ITER ; HIP |
WOS研究方向 | Physics |
WOS类目 | Physics, Multidisciplinary |
语种 | 英语 |
出版者 | IOP PUBLISHING LTD |
WOS记录号 | WOS:000414120500020 |
URI标识 | http://www.irgrid.ac.cn/handle/1471x/2558019 |
专题 | 寒区旱区环境与工程研究所 |
通讯作者 | Luo, G-N |
作者单位 | 1.Chinese Acad Sci ASIPP, Inst Plasma Phys, Hefei, Anhui, Peoples R China 2.Chinese Acad Sci, Inst Modern Phys, Lanzhou, Gansu, Peoples R China 3.Adv Technol & Mat Co Ltd AT&M, Beijing, Peoples R China 4.French Atom Energy Commiss CEA, St Paul Les Durance, France |
推荐引用方式 GB/T 7714 | Li, Q.,Zhao, S. X.,Sun, Z. X.,et al. Development and application of W/Cu flat-type plasma facing components at ASIPP[J]. PHYSICA SCRIPTA,2017,T170:10. |
APA | Li, Q..,Zhao, S. X..,Sun, Z. X..,Xu, Y..,Li, B..,...&Luo, G-N.(2017).Development and application of W/Cu flat-type plasma facing components at ASIPP.PHYSICA SCRIPTA,T170,10. |
MLA | Li, Q.,et al."Development and application of W/Cu flat-type plasma facing components at ASIPP".PHYSICA SCRIPTA T170(2017):10. |
入库方式: iSwitch采集
来源:寒区旱区环境与工程研究所
浏览0
下载0
收藏0
其他版本
除非特别说明,本系统中所有内容都受版权保护,并保留所有权利。