Microstructures and mechanical properties of Mg-2Y-1Mn-1-2Nd alloys fabricated by extrusion
文献类型:期刊论文
作者 | Fang DQ ; Bi GL ; Wang LM ; Li GY ; Jiang ZH |
刊名 | materials science and engineering a-structural materials properties microstructure and processing
![]() |
出版日期 | 2010 |
卷号 | 527期号:16-17页码:4383-4388 |
关键词 | MASS-PERCENT ALLOYS Y-ND ALLOY TENSILE PROPERTIES MAGNESIUM ALLOY BEHAVIOR X=0 DEFORMATION ZK60 |
ISSN号 | 0921-5093 |
通讯作者 | jiang zh |
中文摘要 | microstructures and mechanical properties of the extruded mg-2y-1mn-1 nd and mg-2y-1mn-2nd alloys were investigated. the coarse mg12nd phase particles and fine mg24y5 precipitations form in the mg-2y-1mn-2nd alloy and distribute at the grain boundaries and in the grain interior, but were not observed in the mg-2y-1mn-1 nd alloy due to its relatively lower nd content. tensile tests demonstrated that the mg-2y-1mn-1nd alloy exhibits slightly higher yield and ultimate tensile strengths, but lower elongation to failure at room temperature as compared with the mg-2y-1mn-1nd alloy. in contrast, the mg-2y-1mn-2nd alloy shows higher yield and ultimate tensile strengths and higher elongation to failure at 100 degrees c, 200 degrees c and 300 degrees c than the mg-2y-1mn-2nd alloy. these differences in the tensile mechanical properties of the mg-2y-1mn-2nd alloy and the mg-2y-1mn-1nd alloy arise from the strengthening due to the grain refinement and the precipitation strengthening generated by the coarse mg12nd phase particles and the fine mg24y5 precipitations. (c) 2010 elsevier b.v. all rights reserved. |
收录类别 | SCI收录期刊论文 |
语种 | 英语 |
WOS记录号 | WOS:000278766800100 |
公开日期 | 2012-04-26 |
源URL | [http://ir.ciac.jl.cn/handle/322003/43650] ![]() |
专题 | 长春应用化学研究所_长春应用化学研究所知识产出_期刊论文 |
推荐引用方式 GB/T 7714 | Fang DQ,Bi GL,Wang LM,et al. Microstructures and mechanical properties of Mg-2Y-1Mn-1-2Nd alloys fabricated by extrusion[J]. materials science and engineering a-structural materials properties microstructure and processing,2010,527(16-17):4383-4388. |
APA | Fang DQ,Bi GL,Wang LM,Li GY,&Jiang ZH.(2010).Microstructures and mechanical properties of Mg-2Y-1Mn-1-2Nd alloys fabricated by extrusion.materials science and engineering a-structural materials properties microstructure and processing,527(16-17),4383-4388. |
MLA | Fang DQ,et al."Microstructures and mechanical properties of Mg-2Y-1Mn-1-2Nd alloys fabricated by extrusion".materials science and engineering a-structural materials properties microstructure and processing 527.16-17(2010):4383-4388. |
入库方式: OAI收割
来源:长春应用化学研究所
浏览0
下载0
收藏0
其他版本
除非特别说明,本系统中所有内容都受版权保护,并保留所有权利。