|Author||P. Zhang ; S. X. Li ; Z. F. Zhang|
|Source||Materials Science and Engineering a-Structural Materials Properties Microstructure and Processing|
|Keyword||Crystalline materials Bulk metallic glasses Ceramics Strength Hardness Yield criterion Indentation bulk metallic-glass high-pressure torsion mechanical-properties brittle transition 4000 mpa indentation alloys deformation composites evolution|
|Abstract||Both hardness and strength are the important properties of materials, and they often obey the three times empirical relationship in work-hardened metals and some bulk metallic glasses (BMGs). But the relationships between strength and hardness are quite different for those coarse-grained (CG) and ultrafine-grained materials, brittle BMGs and ceramics. In the present work, some Cu alloys with different microstructures, Zr-, Co-based BMGs and Al(2)O(3) were employed to analyze the general relationship between hardness and strength. Several different relationships could be gotten from the experimental results of different materials available, and three types of indentation morphologies were observed. Indentation with "sink-in" morphology always represents a state of material and one third of hardness is in the range from yield strength to ultimate tensile strength. The other two indentation morphologies induced the fully hardening of material, so hardness could represent the intrinsic mechanical property of materials. The ratios of hardness to strength are found to be affected by the piled-up behaviors and their ability of shear deformation. Combined effect of the two aspects makes hardness approximately be three times of strength in the work-hardened crystalline materials and the shearable BMGs, but higher than three times of strength in the brittle-, annealed BMGs and ceramics. (C) 2011 Elsevier B.V. All rights reserved.|
|P. Zhang,S. X. Li,Z. F. Zhang. General relationship between strength and hardness[J]. Materials Science and Engineering a-Structural Materials Properties Microstructure and Processing,2011,529:62-73.|
|APA||P. Zhang,S. X. Li,&Z. F. Zhang.(2011).General relationship between strength and hardness.Materials Science and Engineering a-Structural Materials Properties Microstructure and Processing,529,62-73.|
|MLA||P. Zhang,et al."General relationship between strength and hardness".Materials Science and Engineering a-Structural Materials Properties Microstructure and Processing 529(2011):62-73.|
Items in the repository are protected by copyright, with all rights reserved, unless otherwise indicated.