中国科学院机构知识库网格
Chinese Academy of Sciences Institutional Repositories Grid
Microstructure and mechanical properties of Cu and Cu-Zn alloys produced by equal channel angular pressing

文献类型:期刊论文

作者Z. J. Zhang ; Q. Q. Duan ; X. H. An ; S. D. Wu ; G. Yang ; Z. F. Zhang
刊名Materials Science and Engineering a-Structural Materials Properties Microstructure and Processing
出版日期2011
卷号528期号:12页码:4259-4267
关键词Cu-Zn alloy Stacking fault energy (SFE) Equal channeling angular pressing (ECAP) Strengthen Ductility stacking-fault energy severe plastic-deformation high-pressure torsion slip mode modification ultrafine-grained cu fcc solid-solutions nanostructured materials simple shear al alloys copper
ISSN号0921-5093
中文摘要Ultrafine-grained (UFG) Cu and Cu-Zn alloy were prepared using equal-channel angular pressing (ECAP) to investigate the effects of stacking fault energy (SFE) on microstructure evolution and mechanical properties. Combining with the previous researches, the grain refinement process of ECAP is divided into three stages based on the variation of tensile strength and plasticity. According to the influences of defects on strength and ductility during plastic deformation, the three stages are discussed in detail by considering the dislocation density, grain and twin boundaries. Besides, the impact of SFE on the strength and ductility of the UFG Cu-Zn alloys are evaluated, indicating that these two mechanical properties can be improved simultaneously in the whole ECAP process either through slightly or widely adjusting the SFE. This significant effect of SFE reflects in two aspects, one is in the microstructure evolution during ECAP processing and the other is in the subsequent tensile plastic deformation, both of which can be achieved through regulating the dislocation motion via changing the SFE. (C) 2011 Elsevier B.V. All rights reserved.
原文出处://WOS:000289389400045
公开日期2012-04-13
源URL[http://210.72.142.130/handle/321006/30945]  
专题金属研究所_中国科学院金属研究所
推荐引用方式
GB/T 7714
Z. J. Zhang,Q. Q. Duan,X. H. An,et al. Microstructure and mechanical properties of Cu and Cu-Zn alloys produced by equal channel angular pressing[J]. Materials Science and Engineering a-Structural Materials Properties Microstructure and Processing,2011,528(12):4259-4267.
APA Z. J. Zhang,Q. Q. Duan,X. H. An,S. D. Wu,G. Yang,&Z. F. Zhang.(2011).Microstructure and mechanical properties of Cu and Cu-Zn alloys produced by equal channel angular pressing.Materials Science and Engineering a-Structural Materials Properties Microstructure and Processing,528(12),4259-4267.
MLA Z. J. Zhang,et al."Microstructure and mechanical properties of Cu and Cu-Zn alloys produced by equal channel angular pressing".Materials Science and Engineering a-Structural Materials Properties Microstructure and Processing 528.12(2011):4259-4267.

入库方式: OAI收割

来源:金属研究所

浏览0
下载0
收藏0
其他版本

除非特别说明,本系统中所有内容都受版权保护,并保留所有权利。