Microstructural evolution and low temperature impact toughness of a Fe-13%Cr-4%Ni-Mo martensitic stainless steel
文献类型：期刊论文
| 作者 | Y. Y. Song ; D. H. Ping ; F. X. Yin ; X. Y. Li ; Y. Y. Li |
| 刊名 | Materials Science and Engineering a-Structural Materials Properties Microstructure and Processing
 |
| 出版日期 | 2010 |
| 卷号 | 527期号:3页码:614-618 |
| 关键词 | Martensitic stainless steel Transmission electron microscopy (TEM) Reversed austenite Microstructure Impact toughness free maraging-steel mechanical-properties retained austenite precipitation embrittlement stability strength m23c6 |
| ISSN号 | 0921-5093 |
| 中文摘要 | The microstructural evolution of a low carbon Fe-13%Cr-4%Ni-Mo (wt.%) martensitic stainless steel has been studied using transmission electron microscopy (TEM) and three-dimensional atom probe (3DAP). The as-quenched sample has a typical lath martensite structure, but carbon atoms were found to form ultra-fine clusters, or carbon-enriched regions, in the martensite. After a single-stage tempering at 680 degrees C. the steel mainly consists of the martensite and a certain amount of fine M(23)C(6) carbides, which act as heterogeneous nucleation sites of the reversed austenite formed in the two-stage tempered (680 degrees C x 4 h + 600 degrees C x 4 h) samples. 3DAP investigations have revealed that the Ni, Cr and Mn atoms are enriched in the reversed austenite as contrasted with the martensite. Phosphorus atoms were uniformly distributed only in martensite. carbon was not detected in either martensite or austenite, and there was no segregation at the martensite-austenite interfaces. Those partitioning behaviors of the alloying elements were thought to be a factor contributing to the stability of the reversed austenite. High impact toughness at low temperature was obtained due to the existence of the reversed austenite. (c) 2009 Published by Elsevier B.V. |
| 原文出处 | |
| 公开日期 | 2012-04-13 |
| 源URL | [http://210.72.142.130/handle/321006/31449]  |
| 专题 | 金属研究所_中国科学院金属研究所 |
| 推荐引用方式 GB/T 7714 | Y. Y. Song,D. H. Ping,F. X. Yin,et al. Microstructural evolution and low temperature impact toughness of a Fe-13%Cr-4%Ni-Mo martensitic stainless steel[J]. Materials Science and Engineering a-Structural Materials Properties Microstructure and Processing,2010,527(3):614-618. |
| APA | Y. Y. Song,D. H. Ping,F. X. Yin,X. Y. Li,&Y. Y. Li.(2010).Microstructural evolution and low temperature impact toughness of a Fe-13%Cr-4%Ni-Mo martensitic stainless steel.Materials Science and Engineering a-Structural Materials Properties Microstructure and Processing,527(3),614-618. |
| MLA | Y. Y. Song,et al."Microstructural evolution and low temperature impact toughness of a Fe-13%Cr-4%Ni-Mo martensitic stainless steel".Materials Science and Engineering a-Structural Materials Properties Microstructure and Processing 527.3(2010):614-618. |
入库方式： OAI收割
来源：金属研究所
浏览0
下载0
收藏0
其他版本
除非特别说明，本系统中所有内容都受版权保护，并保留所有权利。