Influence of tool dimension and welding parameters on microstructure and mechanical properties of friction-stir-welded 6061-T651 aluminum alloy
文献类型：期刊论文
| 作者 | F. C. Liu ; Z. Y. Ma |
| 刊名 | Metallurgical and Materials Transactions a-Physical Metallurgy and Materials Science
 |
| 出版日期 | 2008 |
| 卷号 | 39A期号:10页码:2378-2388 |
| 关键词 | mg-si alloy tensile behavior al-6061 t651 precipitation |
| ISSN号 | 1073-5623 |
| 中文摘要 | Six-millimeter-thick 6061Al-T651 plates were friction stir welded with varied welding parameters and tool dimensions. The low hardness zones (LHZs), determined by constructing the hardness distribution maps around the heat-affected zones, changed the location and inclination with the welding conditions, but the hardness values of the LHZs were mainly dependent on the welding speed. The thermal cycles experienced by the LHZs had approximately the same peak temperature of 360 degrees C to 370 degrees C with varied durations that were governed by the welding speed. The microstructure of the LHZs was characterized by a low density of beta' precipitates, which tended to reduce with increasing the welding speed. The fracture of the welds occurred along the LHZs, and the tensile strength of the welds increased with increasing the welding speed and was independent of the tool dimension and the rotation rate. A heat source zone-isothermal dissolution layer model was proposed to explain the observed effects. |
| 原文出处 | |
| 公开日期 | 2012-04-13 |
| 源URL | [http://210.72.142.130/handle/321006/32937]  |
| 专题 | 金属研究所_中国科学院金属研究所 |
| 推荐引用方式 GB/T 7714 | F. C. Liu,Z. Y. Ma. Influence of tool dimension and welding parameters on microstructure and mechanical properties of friction-stir-welded 6061-T651 aluminum alloy[J]. Metallurgical and Materials Transactions a-Physical Metallurgy and Materials Science,2008,39A(10):2378-2388. |
| APA | F. C. Liu,&Z. Y. Ma.(2008).Influence of tool dimension and welding parameters on microstructure and mechanical properties of friction-stir-welded 6061-T651 aluminum alloy.Metallurgical and Materials Transactions a-Physical Metallurgy and Materials Science,39A(10),2378-2388. |
| MLA | F. C. Liu,et al."Influence of tool dimension and welding parameters on microstructure and mechanical properties of friction-stir-welded 6061-T651 aluminum alloy".Metallurgical and Materials Transactions a-Physical Metallurgy and Materials Science 39A.10(2008):2378-2388. |
入库方式： OAI收割
来源：金属研究所
浏览0
下载0
收藏0
其他版本
除非特别说明，本系统中所有内容都受版权保护，并保留所有权利。