Influence of sintering routes to the mechanical properties of magnesium alloy and its composites produced by PM technique
文献类型：期刊论文
| 作者 | W. Xie ; Y. Liu ; D. S. Li ; J. Zhang ; Z. W. Zhang ; J. Bi |
| 刊名 | Journal of Alloys and Compounds
 |
| 出版日期 | 2007 |
| 卷号 | 431期号:1-2页码:162-166 |
| 关键词 | magnesium matrix composites SiC particle PM technique sintering interfacial reaction matrix composites casting process microstructure mg behavior extrusion strength |
| ISSN号 | 0925-8388 |
| 中文摘要 | Two kinds of sintering routes liquid phase sintering (LS) and solid phase sintering (SS) were used to fabricate Mg-9Al and 15 vol.%oSiCP/Mg-9Al magnesium composite. Mechanical properties of composites and matrix alloys produced by different sintering routes were investigated. Results show that the tensile and yield strength of LS achieved 15%SiCp/Mg9Al-1 were 11.1% and 22.8% higher than those of the matrix respectively. Matrix alloy (Mg9Al-2) and composite (15%SiCp/Mg9A1-2) fabricated via SS process had lower strength values and higher ductility compared to the same material via LS process. The yield strength of 15%SiCp/Mg9Al-1 was found to be as high as 339 MPa which is 25.1% higher than that of 15%SiCp/Mg9Al-2, which was considered to be result from combination effects of refined matrix alloy and certain mount of fine gamma(Mg17Al12) phase which uniformly distribute in the matrix. (c) 2006 Elsevier B.V. All rights reserved. |
| 原文出处 | |
| 公开日期 | 2012-04-13 |
| 源URL | [http://ir.imr.ac.cn/handle/321006/33940]  |
| 专题 | 金属研究所_中国科学院金属研究所 |
| 推荐引用方式 GB/T 7714 | W. Xie,Y. Liu,D. S. Li,et al. Influence of sintering routes to the mechanical properties of magnesium alloy and its composites produced by PM technique[J]. Journal of Alloys and Compounds,2007,431(1-2):162-166. |
| APA | W. Xie,Y. Liu,D. S. Li,J. Zhang,Z. W. Zhang,&J. Bi.(2007).Influence of sintering routes to the mechanical properties of magnesium alloy and its composites produced by PM technique.Journal of Alloys and Compounds,431(1-2),162-166. |
| MLA | W. Xie,et al."Influence of sintering routes to the mechanical properties of magnesium alloy and its composites produced by PM technique".Journal of Alloys and Compounds 431.1-2(2007):162-166. |
入库方式： OAI收割
来源：金属研究所
浏览0
下载0
收藏0
其他版本
除非特别说明，本系统中所有内容都受版权保护，并保留所有权利。