Research on selecting working angle in ball spinning
文献类型：期刊论文
| 作者 | M. S. Li ; S. H. Zhang ; D. C. Kang |
| 刊名 | International Journal of Vehicle Design
 |
| 出版日期 | 2005 |
| 卷号 | 39期号:1-2页码:73-79 |
| 关键词 | ball spinning working angle peeling diameter bulging axial feeding rate radial reduction ball diameter |
| ISSN号 | 0143-3369 |
| 中文摘要 | Ball spinning has been used in manufacturing thin-walled tubes with small diameter. However, its parameters are always determined on the trial-and-error method. Peeling phenomenon may appear if the parameters like working angle are not selected properly. It makes the formed material crashed, curled, or even forced to cover the areas before the balls, and sometimes, it can make the working die damaged. In this paper, a series of experiments are performed to explain the problem of peeling, and the relationships among peeling and axial feeding rate, and the working angle are graphed. |
| 原文出处 | |
| 公开日期 | 2012-04-14 |
| 源URL | [http://ir.imr.ac.cn/handle/321006/34903]  |
| 专题 | 金属研究所_中国科学院金属研究所 |
| 推荐引用方式 GB/T 7714 | M. S. Li,S. H. Zhang,D. C. Kang. Research on selecting working angle in ball spinning[J]. International Journal of Vehicle Design,2005,39(1-2):73-79. |
| APA | M. S. Li,S. H. Zhang,&D. C. Kang.(2005).Research on selecting working angle in ball spinning.International Journal of Vehicle Design,39(1-2),73-79. |
| MLA | M. S. Li,et al."Research on selecting working angle in ball spinning".International Journal of Vehicle Design 39.1-2(2005):73-79. |
入库方式： OAI收割
来源：金属研究所
浏览0
下载0
收藏0
其他版本
除非特别说明，本系统中所有内容都受版权保护，并保留所有权利。