Key technologies of the simulation of the hydrodynamic deep drawing of irregular parts
文献类型：期刊论文
| 作者 | L. H. Lang ; J. Danckert ; K. B. Nielsen ; D. C. Kang ; S. H. Zhang |
| 刊名 | Journal of Materials Processing Technology
 |
| 出版日期 | 2004 |
| 卷号 | 150期号:1-2页码:40-47 |
| 关键词 | sheet forming hydrodynamic deep drawing FE simulation sheet-metal pairs pressure |
| ISSN号 | 0924-0136 |
| 中文摘要 | Because of the complex boundary conditions to be dealt with, it is a difficult task to simulate the hydrodynamic deep drawing of irregular cups. If the boundary conditions on the loading of liquid pressure onto the blank are not considered correctly, the results obtained from the FEM will differ greatly from the experimental results. In this paper a mathematical model is proposed for the liquid flow between the flange and the die when drawing a tapered rectangular cup using hydrodynamic deep drawing. The proposed model was incorporated into a commercial FEM software (LS-DYNA3D), successfully. Process parameters including die entrance radius, lubrication, blank geometry, and the control of material flow for the hydrodynamic deep drawing of a tapered rectangular cup were investigated. Based an experimental unit mounted onto a single-action hydraulic press, the hydrodynamic deep drawing process was also investigated experimentally. It was shown that the FE results matched well with the experimental results, which may suggest that the proposed method can be used to determine the main process parameters during the hydrodynamic deep drawing of irregular cups. (C) 2004 Elsevier B.V. All rights reserved. |
| 原文出处 | |
| 公开日期 | 2012-04-14 |
| 源URL | [http://ir.imr.ac.cn/handle/321006/35398]  |
| 专题 | 金属研究所_中国科学院金属研究所 |
| 推荐引用方式 GB/T 7714 | L. H. Lang,J. Danckert,K. B. Nielsen,et al. Key technologies of the simulation of the hydrodynamic deep drawing of irregular parts[J]. Journal of Materials Processing Technology,2004,150(1-2):40-47. |
| APA | L. H. Lang,J. Danckert,K. B. Nielsen,D. C. Kang,&S. H. Zhang.(2004).Key technologies of the simulation of the hydrodynamic deep drawing of irregular parts.Journal of Materials Processing Technology,150(1-2),40-47. |
| MLA | L. H. Lang,et al."Key technologies of the simulation of the hydrodynamic deep drawing of irregular parts".Journal of Materials Processing Technology 150.1-2(2004):40-47. |
入库方式： OAI收割
来源：金属研究所
浏览0
下载0
收藏0
其他版本
除非特别说明，本系统中所有内容都受版权保护，并保留所有权利。