High temperature scaling of two phase Fe-50Cu alloy with controlled microstructures
文献类型：期刊论文
| 作者 | Y. S. Li ; F. G. Wang ; Y. Niu ; W. T. Wu |
| 刊名 | Materials Science and Engineering a-Structural Materials Properties Microstructure and Processing
 |
| 出版日期 | 2001 |
| 卷号 | 315期号:1-2页码:245-249 |
| 关键词 | Fe-50Cu two-phase alloy microstructure selective oxidation 2-phase binary-alloys low oxidant pressures fe-cu alloys internal oxidation selective oxidation scales nanocrystallization oxygen |
| ISSN号 | 0921-5093 |
| 中文摘要 | In order to study the effect of microstructure changes on the selective oxidation of the most reactive component in two-phase alloys, the oxidation behaviors of an as-cast Fe-50Cu alloy and its sputtered coating with quite different grain sizes were examined at 800 degreesC. For the as-cast Fe-50Cu alloy, a complex scale formed after air oxidation, containing an outermost layer of copper oxide (CuO + Cu2O) plus an inner region composed of a mixture of the oxides of Fe and Cu as well as some Fe-Cu double oxides. A region of internal oxidation of Fe was also observed. Under oxygen pressure low enough that only Fe can be oxidized, a simultaneous external and internal oxidation of Fe was present. However, a single external Fe oxide scale formed in Fe-50Cu sputtered coating when the grain size was largely reduced. The transition of the oxidation modes above indicates that the grain size reduction can promote the selective oxidation of Fe effectively. The mechanism is mainly attributed to the significantly extended solubility of iron in copper, and also to the presence of a large number of grain boundaries in the coating, as a direct consequence of the grain size reduction, which may act as short-circuit diffusion paths for the fast outward diffusion of iron during oxidation process. (C) 2001 Elsevier Science B.V. All rights reserved. |
| 原文出处 | |
| 公开日期 | 2012-04-14 |
| 源URL | [http://ir.imr.ac.cn/handle/321006/36709]  |
| 专题 | 金属研究所_中国科学院金属研究所 |
| 推荐引用方式 GB/T 7714 | Y. S. Li,F. G. Wang,Y. Niu,et al. High temperature scaling of two phase Fe-50Cu alloy with controlled microstructures[J]. Materials Science and Engineering a-Structural Materials Properties Microstructure and Processing,2001,315(1-2):245-249. |
| APA | Y. S. Li,F. G. Wang,Y. Niu,&W. T. Wu.(2001).High temperature scaling of two phase Fe-50Cu alloy with controlled microstructures.Materials Science and Engineering a-Structural Materials Properties Microstructure and Processing,315(1-2),245-249. |
| MLA | Y. S. Li,et al."High temperature scaling of two phase Fe-50Cu alloy with controlled microstructures".Materials Science and Engineering a-Structural Materials Properties Microstructure and Processing 315.1-2(2001):245-249. |
入库方式： OAI收割
来源：金属研究所
浏览0
下载0
收藏0
其他版本
除非特别说明，本系统中所有内容都受版权保护，并保留所有权利。