Analysis of filling process of Ti6Al4V alloy melt poured in permanent mold during centrifugal casting process
文献类型：期刊论文
| 作者 | W. B. Sheng ; D. Li ; R. Yang ; Y. Y. Liu ; J. J. Guo ; J. Jia |
| 刊名 | Transactions of Nonferrous Metals Society of China
 |
| 出版日期 | 2001 |
| 卷号 | 11期号:3页码:353-357 |
| 关键词 | flow status Ti6A14V alloy cross-sectional area permanent mold centrifugal casting intermetallics aluminides |
| ISSN号 | 1003-6326 |
| 中文摘要 | Ti6Al4V hip joint was foundered and the filling process of the melt poured in permanent mould during the centrifugal casting process was analyzed and the mathematical model of the filling process was established. Furthermore, the mathematical model was validated with a wax-model experiment. Calculating results show that the centrifugal field has an important influence on the filling process and the melt fills the mould with variational cross-sectional area and inclined angle. The cross-sectional area is in inverse proportion to the filling speed and its decreasing speed becomes fast with increasing rotating speed. The tangential value of the melt cross-sectional free-surface inclined angle is in direct proportion to the filling speed and the inclined angle increases with the filling length. Change curves of the cross-sectional inclined angle and area were obtained by the wax-model experiment when the rotating speeds were 60, 90 and 120 r/min respectively, which shows that the mathematical model is consistent with the experimental results. |
| 原文出处 | |
| 公开日期 | 2012-04-14 |
| 源URL | [http://ir.imr.ac.cn/handle/321006/36797]  |
| 专题 | 金属研究所_中国科学院金属研究所 |
| 推荐引用方式 GB/T 7714 | W. B. Sheng,D. Li,R. Yang,et al. Analysis of filling process of Ti6Al4V alloy melt poured in permanent mold during centrifugal casting process[J]. Transactions of Nonferrous Metals Society of China,2001,11(3):353-357. |
| APA | W. B. Sheng,D. Li,R. Yang,Y. Y. Liu,J. J. Guo,&J. Jia.(2001).Analysis of filling process of Ti6Al4V alloy melt poured in permanent mold during centrifugal casting process.Transactions of Nonferrous Metals Society of China,11(3),353-357. |
| MLA | W. B. Sheng,et al."Analysis of filling process of Ti6Al4V alloy melt poured in permanent mold during centrifugal casting process".Transactions of Nonferrous Metals Society of China 11.3(2001):353-357. |
入库方式： OAI收割
来源：金属研究所
浏览0
下载0
收藏0
其他版本
除非特别说明，本系统中所有内容都受版权保护，并保留所有权利。