Shrinkage porosity criteria and optimized design of a 100-ton 30Cr(2)Ni(4)MoV forging ingot
文献类型：期刊论文
| 作者 | J. Q. Wang ; P. X. Fu ; H. W. Liu ; D. Z. Li ; Y. Y. Li |
| 刊名 | Materials & Design
 |
| 出版日期 | 2012 |
| 卷号 | 35页码:446-456 |
| 关键词 | Ferrous metals and alloys Casting Shrinkage castings |
| ISSN号 | 0261-3069 |
| 中文摘要 | The heavy 30Cr(2)Ni(4)MoV forging ingots have been extensively used to fabricate the low-pressure rotors, which play a crucial role in the large nuclear power plant. However, the quality of the heavy ingots has been commonly affected by various inner defects. One of the most typical defects is the centerline shrinkage porosity, which has been found to be always accompanied by inclusions and macrosegregation. Within this context, a 100-ton 30Cr(2)Ni(4)MoV ingot was cut and the axle plane of it was analyzed to observe the distribution and size of the shrinkage porosity in the sectioned surface. On basis of these experimental results, through the FEM (Finite Element Method) simulation several criteria of the centerline shrinkage porosity have been clarified. Of them, the best criterion has been found to be the condition wunder G=R-s(0:5)<2.5 degrees C s(0.5) mm (1.5) (G and R-s are the temperature gradient and solidification rate, respectively). With this criterion, the distribution and size of the simulated centerline shrinkage porosity agree well with the experimental results observed by the sectioning and ultrasonic testing. Subsequently, by utilizing the optimized design, the simulated results uncovered that the centerline shrinkage porosity could be nearly eliminated. Thereby, offering a possibility by significantly improving the performance for the nuclear power low-pressure rotors. (C) 2011 Elsevier Ltd. All rights reserved. |
| 原文出处 | |
| 公开日期 | 2013-02-05 |
| 源URL | [http://ir.imr.ac.cn/handle/321006/60293]  |
| 专题 | 金属研究所_中国科学院金属研究所 |
| 推荐引用方式 GB/T 7714 | J. Q. Wang,P. X. Fu,H. W. Liu,et al. Shrinkage porosity criteria and optimized design of a 100-ton 30Cr(2)Ni(4)MoV forging ingot[J]. Materials & Design,2012,35:446-456. |
| APA | J. Q. Wang,P. X. Fu,H. W. Liu,D. Z. Li,&Y. Y. Li.(2012).Shrinkage porosity criteria and optimized design of a 100-ton 30Cr(2)Ni(4)MoV forging ingot.Materials & Design,35,446-456. |
| MLA | J. Q. Wang,et al."Shrinkage porosity criteria and optimized design of a 100-ton 30Cr(2)Ni(4)MoV forging ingot".Materials & Design 35(2012):446-456. |
入库方式： OAI收割
来源：金属研究所
浏览0
下载0
收藏0
其他版本
除非特别说明，本系统中所有内容都受版权保护，并保留所有权利。