Phase transformation behavior of a Mn containing beta-solidifying gamma-TiAl alloy during continuous cooling
文献类型：期刊论文
| 作者 | Xu, Hao1,2; Li, Xiaobing2; Xing, Weiwei2; Shu, Lei2; Ma, Yingche2; Liu, Kui2 |
| 刊名 | INTERMETALLICS
 |
| 出版日期 | 2018-08-01 |
| 卷号 | 99页码:51-58 |
| ISSN号 | 0966-9795 |
| 关键词 | Titanium aluminide Phase transformation Microstructure Kinetics CCT diagram |
| DOI | 10.1016/j.intermet.2018.05.004 |
| 通讯作者 | Li, Xiaobing(xbli@imr.ac.cn) |
| 英文摘要 | The research was mainly focused on the phase transformation of Ti-42Al-5Mn (at%) alloy produced by vacuum induction melting (VIM) and vacuum arc remelting (VAR) followed by wrought process. The phase transformation kinetics of the alloy during continuous cooling under the cooling rates of 0.1 degrees C/s, 0.5 degrees C/s, 2 degrees C/s, 10 degrees C/ s, 50 degrees C/s, and 200 degrees C/s were identified by the Gleeble-3800 system, which is finally used to construct a schematic continuous cooling transformation (CCT) diagram of this alloy. The related phase composition, microstructure and property of the alloy were studied using X-ray diffraction (XRD), electron probe micro analyzer (EPMA), transmission electron microscope (TEM) and Vickers hardness (HV). It shows that six kinds of phase transformation are existed during continuous cooling from 1300 degrees C with the cooling rates of 0.1 degrees C/s, 0.5 degrees C/s, 2 degrees C/s, 10 degrees C/s, 50 degrees C/s, 200 degrees C/s and WQ, including beta ->alpha(2)', beta ->alpha, beta ->gamma, beta ->beta(o)/alpha ->alpha(2), alpha(2)->alpha(2)/gamma and alpha(2)/gamma ->beta(o,sec).It reveals that partial transformations would be inhibited when the cooling rate is relatively high. The martensitic structures (alpha(2)') obtained by beta ->alpha(2) were formed under the WQ condition after holding at 1300 degrees C for 5min, and it will be completely restrained below the cooling rate of WQ. For the beta ->gamma, it is restrained if the cooling rates are higher than 50 degrees C/s. The alpha(2)->alpha(2)/gamma could be also suppressed when cooling with 200 degrees C/s, and the gamma lath within the supersaturated alpha(2)-grains would be formed at lower cooling rate below 50 degrees C/s. For 0.5 degrees C/s and 0.1 degrees C/s, a small amount of dotted beta(o) (beta(o,sec)) phases can be formed in the lamellar interfaces, which is proved the reaction products of alpha(2)/gamma ->beta(o,sec). Furthermore, the effect of cooling rates on the microstructure, including interlamellar spacing (lambda) and gamma grains are also identified and discussed. |
| WOS研究方向 | Chemistry ; Materials Science ; Metallurgy & Metallurgical Engineering |
| 语种 | 英语 |
| 出版者 | ELSEVIER SCI LTD |
| WOS记录号 | WOS:000436221800008 |
| 源URL | [http://ir.imr.ac.cn/handle/321006/128655]  |
| 专题 | 金属研究所_中国科学院金属研究所 |
| 通讯作者 | Li, Xiaobing |
| 作者单位 | 1.Univ Chinese Acad Sci, Beijing 100049, Peoples R China 2.Chinese Acad Sci, Inst Met Res, Shenyang 110016, Liaoning, Peoples R China |
| 推荐引用方式 GB/T 7714 | Xu, Hao,Li, Xiaobing,Xing, Weiwei,et al. Phase transformation behavior of a Mn containing beta-solidifying gamma-TiAl alloy during continuous cooling[J]. INTERMETALLICS,2018,99:51-58. |
| APA | Xu, Hao,Li, Xiaobing,Xing, Weiwei,Shu, Lei,Ma, Yingche,&Liu, Kui.(2018).Phase transformation behavior of a Mn containing beta-solidifying gamma-TiAl alloy during continuous cooling.INTERMETALLICS,99,51-58. |
| MLA | Xu, Hao,et al."Phase transformation behavior of a Mn containing beta-solidifying gamma-TiAl alloy during continuous cooling".INTERMETALLICS 99(2018):51-58. |
入库方式： OAI收割
来源：金属研究所
浏览0
下载0
收藏0
其他版本
除非特别说明，本系统中所有内容都受版权保护，并保留所有权利。