Effect of Holding Time During Sintering on Microstructure and Properties of 3D Printed Alumina Ceramics
文献类型：期刊论文
| 作者 | Pan, Yu; Li, He; Liu, Yongsheng; Liu, Yansong; Hu, Kehui; Wang, Ning; Lu, Zhigang; Liang, Jingjing; He, Sujun |
| 刊名 | FRONTIERS IN MATERIALS
 |
| 出版日期 | 2020-04-02 |
| 卷号 | 7 |
| DOI | 10.3389/fmats.2020.00054 |
| 英文摘要 | In this work, alumina ceramics were formed via stereolithography-based 3D printing technology in order to fabricate ceramic cores in a fast and cost-effective way. Effects of holding time during sintering on microstructure and properties of alumina ceramics were investigated. Sintered alumina ceramics were made up of layered structures due to layer-by-layer forming method. In addition, interlayer spacing decreased with the increase in holding time. Average particle size, shrinkage, crystallite size, flexural strength, and hardness increased with the increase in holding time due to strong interfacial bonding among alumina particles. Open porosity decreased slightly as holding time increased. Moreover, it was found that holding time had little influence on bulk density, phase composition, and chemical bonds of the ceramics. The shrinkage in Z direction was about 1.8 times higher than that in X or Y directions due to layered structure caused by 3D printing forming method. The optimum holding time was 90 min, which resulted in ceramics with interlayering spacing of 11.8 mu m, shrinkage of 2.1% in X direction, 2.1% in Y direction, and 4.1% in Z direction, flexural strength of 20.7 MPa, nano-indentation hardness of 17.6 GPa, Vickers hardness of 114.3 HV, bulk density of 2.5 g/cm(3), and open porosity of 39.0%. |
| WOS记录号 | WOS:000596941100001 |
| 源URL | [http://ir.imr.ac.cn/handle/321006/155708]  |
| 专题 | 金属研究所_中国科学院金属研究所 |
| 推荐引用方式 GB/T 7714 | Pan, Yu,Li, He,Liu, Yongsheng,et al. Effect of Holding Time During Sintering on Microstructure and Properties of 3D Printed Alumina Ceramics[J]. FRONTIERS IN MATERIALS,2020,7. |
| APA | Pan, Yu.,Li, He.,Liu, Yongsheng.,Liu, Yansong.,Hu, Kehui.,...&He, Sujun.(2020).Effect of Holding Time During Sintering on Microstructure and Properties of 3D Printed Alumina Ceramics.FRONTIERS IN MATERIALS,7. |
| MLA | Pan, Yu,et al."Effect of Holding Time During Sintering on Microstructure and Properties of 3D Printed Alumina Ceramics".FRONTIERS IN MATERIALS 7(2020). |
入库方式： OAI收割
来源：金属研究所
浏览0
下载0
收藏0
其他版本
除非特别说明，本系统中所有内容都受版权保护，并保留所有权利。