Physico-mechanical properties of granite after cyclic thermal shock
文献类型:期刊论文
作者 | Yu, Peiyang1,4; Pan, Peng-Zhi1,3,4; Feng, Guangliang1,4; Wu, Zhenhua1,4; Zhao, Shankun2 |
刊名 | JOURNAL OF ROCK MECHANICS AND GEOTECHNICAL ENGINEERING
![]() |
出版日期 | 2020-08-01 |
卷号 | 12期号:4页码:693-706 |
关键词 | Beishan granite Cyclic thermal shock Digital image correlation (DIC) Acoustic emission (AE) Physico-mechanical properties Continuum damage model |
ISSN号 | 1674-7755 |
DOI | 10.1016/j.jrmge.2020.03.001 |
英文摘要 | Understanding rock mechanical behaviors after thermal shock is critically important for practical engineering application. In this context, physico-mechanical properties of Beishan granite, Gansu Province, China after cyclic thermal shock were studied using digital image correlation (DIC), acoustic emission (AE) monitoring, and microscopic observation. The results show that the peak strength and elastic modulus decreased gradually with increase in thermal shock cycle. However, the above two parameters showed no further changes after 10 thermal shock cycles. The loading stress ratio (i.e. the ratio of the current loading stress level to the peak stress in this state) corresponding to the occurrence of the uneven principal strain field and the local strain concentration zone on the surface of the granite specimen decreased with increase in thermal shock cycle. Three transformation forms of the standard deviation curves of the surface principal strain were found. For granite with fewer thermal shock cycles (e.g. no more than 2 cycles), the standard deviation curves exhibited approximately exponential growth in exponential form. With increase in thermal shock cycle, the S-shaped curve was dominant. After 10 thermal shock cycles, an approximate ladder-shaped curve was observed. It is displayed that AE activity was mainly concentrated around the peak strength zone of the granite specimen when the rock samples underwent fewer thermal shock cycles. With increase in thermal shock cycle, AE activity could occur at low loading stress levels. Microscopic observation further confirmed these scenarios, which showed that more microcracks were induced with increase in thermal shock cycle. The number of induced microcracks at the edge location of the granite specimen was significantly larger than that at the interior location. Finally, a continuum damage model was proposed to describe the damage evolution of the granite specimen after cyclic thermal shock during loading. (C) 2020 Institute of Rock and Soil Mechanics, Chinese Academy of Sciences. Production and hosting by Elsevier B.V. |
资助项目 | State Key Research Development Program of China[2017YFC0804203] ; National Nature Science Foundation of China[51621006] ; Key Research Program of Frontier Sciences, Chinese Academy of Sciences[QYZDB-SSW-DQC029] |
WOS研究方向 | Engineering |
语种 | 英语 |
WOS记录号 | WOS:000560491300003 |
出版者 | SCIENCE PRESS |
源URL | [http://119.78.100.198/handle/2S6PX9GI/24641] ![]() |
专题 | 中科院武汉岩土力学所 |
通讯作者 | Pan, Peng-Zhi |
作者单位 | 1.Chinese Acad Sci, Inst Rock & Soil Mech, State Key Lab Geomech & Geotech Engn, Wuhan 430071, Peoples R China 2.China Coal Res Inst, State Key Lab Coal Resources High Efficient Min &, Beijing 100013, Peoples R China 3.Northeastern Univ, Key Lab, Minist Educ Safe Min Deep Met Mines, Shenyang 110819, Peoples R China 4.Univ Chinese Acad Sci, Beijing 100049, Peoples R China |
推荐引用方式 GB/T 7714 | Yu, Peiyang,Pan, Peng-Zhi,Feng, Guangliang,et al. Physico-mechanical properties of granite after cyclic thermal shock[J]. JOURNAL OF ROCK MECHANICS AND GEOTECHNICAL ENGINEERING,2020,12(4):693-706. |
APA | Yu, Peiyang,Pan, Peng-Zhi,Feng, Guangliang,Wu, Zhenhua,&Zhao, Shankun.(2020).Physico-mechanical properties of granite after cyclic thermal shock.JOURNAL OF ROCK MECHANICS AND GEOTECHNICAL ENGINEERING,12(4),693-706. |
MLA | Yu, Peiyang,et al."Physico-mechanical properties of granite after cyclic thermal shock".JOURNAL OF ROCK MECHANICS AND GEOTECHNICAL ENGINEERING 12.4(2020):693-706. |
入库方式: OAI收割
来源:武汉岩土力学研究所
浏览0
下载0
收藏0
其他版本
除非特别说明,本系统中所有内容都受版权保护,并保留所有权利。