Adaptive Spiral Tool Path Generation for Diamond Turning of Large Aperture Freeform Optics
文献类型：期刊论文
| 作者 | D.F.Wang; Y.X.Sui; H.J.Yang; D.Li |
| 刊名 | Materials
 |
| 出版日期 | 2019 |
| 卷号 | 12期号:5页码:15 |
| 关键词 | freeform optics,slow tool servo,tool path generation,large aperture,optics,surfaces,design,Materials Science |
| ISSN号 | 1996-1944 |
| DOI | 10.3390/ma12050810 |
| 英文摘要 | Slow tool servo (STS) diamond turning is a well-developed technique for freeform optics machining. Due to low machining efficiency, fluctuations in side-feeding motion and redundant control points for large aperture optics, this paper reports a novel adaptive tool path generation (ATPG) for STS diamond turning. In ATPG, the sampling intervals both in feeding and cutting direction are independently controlled according to interpolation error and cutting residual tolerance. A smooth curve is approximated to the side-feeding motion for reducing the fluctuations in feeding direction. Comparison of surface generation of typical freeform surfaces with ATPG and commercial software DiffSys is conducted both theoretically and experimentally. The result demonstrates that the ATPG can effectively reduce the volume of control points, decrease the vibration of side-feeding motion and improve machining efficiency while surface quality is well maintained for large aperture freeform optics. |
| 语种 | 英语 |
| 源URL | [http://ir.ciomp.ac.cn/handle/181722/63020]  |
| 专题 | 中国科学院长春光学精密机械与物理研究所 |
| 推荐引用方式 GB/T 7714 | D.F.Wang,Y.X.Sui,H.J.Yang,et al. Adaptive Spiral Tool Path Generation for Diamond Turning of Large Aperture Freeform Optics[J]. Materials,2019,12(5):15. |
| APA | D.F.Wang,Y.X.Sui,H.J.Yang,&D.Li.(2019).Adaptive Spiral Tool Path Generation for Diamond Turning of Large Aperture Freeform Optics.Materials,12(5),15. |
| MLA | D.F.Wang,et al."Adaptive Spiral Tool Path Generation for Diamond Turning of Large Aperture Freeform Optics".Materials 12.5(2019):15. |
入库方式： OAI收割
浏览0
下载0
收藏0
其他版本
除非特别说明，本系统中所有内容都受版权保护，并保留所有权利。