Processing and Inspection Method for Parts with Small Angle
文献类型：期刊论文
| 作者 | Y. Zhai,H. Jiang and G. Mei |
| 刊名 | Binggong Xuebao/Acta Armamentarii
 |
| 出版日期 | 2020 |
| 卷号 | 41期号:7页码:1417-1422 |
| ISSN号 | 10001093 |
| DOI | 10.3969/j.issn.1000-1093.2020.07.020 |
| 英文摘要 | A set of processing and testing methods for optical elements with small angles are proposed for the assembly process of a large-scale infrared camera. 6 mirrors are added in processing and inspection, and the heights of the four feature points, the reverse sides and the initial angles of the machined element with 4 silicon carbide lenses are monitored. 6 mirrors are inspected using an interferometer. The angle between the processed surface and the initial surface of element and the height difference between the high point and the low point of element are calculated from the obtained interference fringes for guiding the amount of finish and machining angle of further processing. The value of the angle between the mirror surface of back surface and the back surface of element is calculated by the difference between their interference fringes. By processing, on the 80 mm-wide adjustable pad, an angle between the top and bottom surfaces finally is 0.21", and the height difference between the upper edge and lower edge of adjustable pad is 0.100 (=632.8 nm), that is, 63.28 nm, which is within the error range. The adjustable pad is mounted in an optical system, which meets the design requirements through mechanical and thermo-optical tests. The results show that it is feasible to use optical machining method to obtain the plane with the required small angle for small-sized mechanical parts. An interferometer is used to perform interference detection on the surface of auxiliary mirror, and the amount of finish on the surface of element is calculated. The surface height difference of the processed parts calculated from the interferogram of auxiliary mirror can meet the needs of the optical system installation and adjustment. 2020, Editorial Board of Acta Armamentarii. All right reserved. |
| URL标识 | 查看原文 |
| 源URL | [http://ir.ciomp.ac.cn/handle/181722/64812]  |
| 专题 | 中国科学院长春光学精密机械与物理研究所 |
| 推荐引用方式 GB/T 7714 | Y. Zhai,H. Jiang and G. Mei. Processing and Inspection Method for Parts with Small Angle[J]. Binggong Xuebao/Acta Armamentarii,2020,41(7):1417-1422. |
| APA | Y. Zhai,H. Jiang and G. Mei.(2020).Processing and Inspection Method for Parts with Small Angle.Binggong Xuebao/Acta Armamentarii,41(7),1417-1422. |
| MLA | Y. Zhai,H. Jiang and G. Mei."Processing and Inspection Method for Parts with Small Angle".Binggong Xuebao/Acta Armamentarii 41.7(2020):1417-1422. |
入库方式： OAI收割
浏览0
下载0
收藏0
其他版本
除非特别说明，本系统中所有内容都受版权保护，并保留所有权利。