Preparation and characterization of LaNiO3 A/F ratio-sensitive thin film by sol-gel process based on amorphous citrate precursors
文献类型：期刊论文
| 作者 | Lu, XC; Xu, TX; Dong, XH |
| 刊名 | SENSORS AND ACTUATORS B-CHEMICAL
 |
| 出版日期 | 2000-08-10 |
| 卷号 | 67期号:1-2页码:24-28 |
| 关键词 | lanthanum nickelate thin film A/F ratio-sensing sol-gel process |
| ISSN号 | 0925-4005 |
| 其他题名 | Sens. Actuator B-Chem. |
| 中文摘要 | Thin film of lanthanum nickelate (LaNiO3) has been prepared by the sol-gel process based on the amorphous citrate precursors. The sheet resistance of LaNiO3 thin film greatly decreases and trends towards a stable value with increasing the repeated dipping-calcining cycles. The sheet resistance of about 1.2 mu m thick LaNiO3 thin film produced by the dipping-calcining 10 cycles is about 22.4 Omega at room temperature and less sensitive to temperature in the P-O2 range from 10(3.3) to 10(5) Pa or in the lean-burn region (lambda = 1.15). The sensitivity and response characteristics of the LaNiO3 thin film sensor have been investigated in the exhaust gas of air-propane combustion. It has been shown that thin film sensor has high sensitivity, fairly good response and reproducibility from h = 1.15 to 0.85 and vice versa, and no temperature compensation is needed for stoichiometric air/fuel control over a 300-800 degrees C range. The thin film sensor is a promising A/F sensitive sensor that needs no temperature compensation. (C) 2000 Elsevier Science S.A. All rights reserved. |
| 英文摘要 | Thin film of lanthanum nickelate (LaNiO3) has been prepared by the sol-gel process based on the amorphous citrate precursors. The sheet resistance of LaNiO3 thin film greatly decreases and trends towards a stable value with increasing the repeated dipping-calcining cycles. The sheet resistance of about 1.2 mu m thick LaNiO3 thin film produced by the dipping-calcining 10 cycles is about 22.4 Omega at room temperature and less sensitive to temperature in the P-O2 range from 10(3.3) to 10(5) Pa or in the lean-burn region (lambda = 1.15). The sensitivity and response characteristics of the LaNiO3 thin film sensor have been investigated in the exhaust gas of air-propane combustion. It has been shown that thin film sensor has high sensitivity, fairly good response and reproducibility from h = 1.15 to 0.85 and vice versa, and no temperature compensation is needed for stoichiometric air/fuel control over a 300-800 degrees C range. The thin film sensor is a promising A/F sensitive sensor that needs no temperature compensation. (C) 2000 Elsevier Science S.A. All rights reserved. |
| WOS标题词 | Science & Technology ; Physical Sciences ; Technology |
| 类目[WOS] | Chemistry, Analytical ; Electrochemistry ; Instruments & Instrumentation |
| 研究领域[WOS] | Chemistry ; Electrochemistry ; Instruments & Instrumentation |
| 关键词[WOS] | OXYGEN SENSOR ; OXIDE |
| 收录类别 | SCI |
| 原文出处 | |
| 语种 | 英语 |
| WOS记录号 | WOS:000088553000002 |
| 公开日期 | 2013-11-15 |
| 版本 | 出版稿 |
| 源URL | [http://ir.ipe.ac.cn/handle/122111/6023]  |
| 专题 | 过程工程研究所_研究所（批量导入） |
| 作者单位 | 1.Chinese Acad Sci, Inst Chem Met, Beijing 100080, Peoples R China 2.Tianjin Univ, Inst Mat Sci & Engn, Tianjin 300072, Peoples R China |
| 推荐引用方式 GB/T 7714 | Lu, XC,Xu, TX,Dong, XH. Preparation and characterization of LaNiO3 A/F ratio-sensitive thin film by sol-gel process based on amorphous citrate precursors[J]. SENSORS AND ACTUATORS B-CHEMICAL,2000,67(1-2):24-28. |
| APA | Lu, XC,Xu, TX,&Dong, XH.(2000).Preparation and characterization of LaNiO3 A/F ratio-sensitive thin film by sol-gel process based on amorphous citrate precursors.SENSORS AND ACTUATORS B-CHEMICAL,67(1-2),24-28. |
| MLA | Lu, XC,et al."Preparation and characterization of LaNiO3 A/F ratio-sensitive thin film by sol-gel process based on amorphous citrate precursors".SENSORS AND ACTUATORS B-CHEMICAL 67.1-2(2000):24-28. |
入库方式： OAI收割
来源：过程工程研究所
浏览0
下载0
收藏0
其他版本
除非特别说明，本系统中所有内容都受版权保护，并保留所有权利。