Flow characteristics of hypersonic inlets with different cowl-lip blunting methods
文献类型：期刊论文
| 作者 | Lu HB(卢洪波) ; Yue LJ(岳连捷); Zhang XY(张新宇); Yue LJ(岳连捷)
|
| 刊名 | SCIENCE CHINA-Physics, Mechanics & Astronomy
 |
| 出版日期 | 2014-04 |
| 卷号 | 57期号:4页码:741-752 |
| 通讯作者邮箱 | yuelj@imech.ac.cn |
| 关键词 | hypersonic inlet cowl-lip bluntness flow characteristics shock pattern shock interference |
| ISSN号 | 1674-7348 |
| 通讯作者 | 岳连捷 |
| 中文摘要 | Under hypersonic flight conditions, the sharp cowl-lip leading edges have to be blunted because of the severe aerodynamic heating. This paper proposes four cowl-lip blunting methods and studies the corresponding flow characteristics and performances of the generic hypersonic inlets by numerical simulation under the design conditions of a flight Mach number of 6 and an altitude of 26 km. The results show that the local shock interference patterns in the vicinity of the blunted cowl-lips have a substantial influence on the flow characteristics of the hypersonic inlets even though the blunting radius is very small, which contribute to a pronounced degradation of the inlet performance. The Equal Length blunting Manner (ELM) is the most optimal in that a nearly even reflection of the ramp shock produces an approximately straight and weak cowl reflection shock. The minimal total pressure loss, the lowest cowl drag, maximum mass-capture and the minimal aeroheating are achieved for the hypersonic inlet. For the other blunting manners, the ramp shock cannot reflect evenly and produces more curved cowl reflection shock. The Type V shock interference pattern occurs for the Cross Section Cutting blunting Manner (CSCM) and the strongest cowl reflection shock gives rise to the largest flow loss and drag. The cowl-lip blunted by the other two blunting manners is subjected to the shock interference pattern that transits with an increase in the blunting radius. Accordingly, the peak heat flux does not fall monotonously with the blunting radius increasing. Moreover, the cowl-lip surface suffers from severe aerothermal load when the shear layer or the supersonic jet impinges on the wall. |
| 学科主题 | 高超声速气体动力学 |
| 分类号 | 二类/Q3 |
| 收录类别 | SCI ; EI |
| 语种 | 英语 |
| WOS记录号 | WOS:000332978500022 |
| 公开日期 | 2014-04-15 |
| 源URL | [http://dspace.imech.ac.cn/handle/311007/48723]  |
| 专题 | 力学研究所_高温气体动力学国家重点实验室 |
| 通讯作者 | Yue LJ(岳连捷) |
| 推荐引用方式 GB/T 7714 | Lu HB,Yue LJ,Zhang XY,et al. Flow characteristics of hypersonic inlets with different cowl-lip blunting methods[J]. SCIENCE CHINA-Physics, Mechanics & Astronomy,2014,57(4):741-752. |
| APA | Lu HB,Yue LJ,Zhang XY,&岳连捷.(2014).Flow characteristics of hypersonic inlets with different cowl-lip blunting methods.SCIENCE CHINA-Physics, Mechanics & Astronomy,57(4),741-752. |
| MLA | Lu HB,et al."Flow characteristics of hypersonic inlets with different cowl-lip blunting methods".SCIENCE CHINA-Physics, Mechanics & Astronomy 57.4(2014):741-752. |
入库方式： OAI收割
来源：力学研究所
浏览0
下载0
收藏0
其他版本
除非特别说明，本系统中所有内容都受版权保护，并保留所有权利。