Removal of arsenic by a granular Fe-Ce oxide adsorbent: Fabrication conditions and performance
文献类型：期刊论文
| 作者 | Zhang, Yu ; Dou, Xiaomin; Zhao, Bei; Yang, Min; Takayama, Tomoo; Kato, Shigeru
|
| 刊名 | CHEMICAL ENGINEERING JOURNAL
 |
| 出版日期 | 2010-08-01 |
| 卷号 | 162期号:1页码:164-170 |
| 关键词 | Granular Fe-Ce oxide Vibration dropping method As(V) removal |
| 中文摘要 | Iron-cerium hydroxide (Fe-Ce), which has shown a high arsenic (V) (As(V)) adsorption capacity in previous studies, was granulated using the vibration dropping method used to prepare small-sized fuel particles. Fabrication studies showed that the sintering process could not be used in the preparation of the granular Fe-Ce (GFC) adsorbent and that the optimum grain size was 1.0 mm for As(V) removal. The optimum sized GFC (GFC-1.0 mm) exhibited a Freundlich adsorption of 18.2 and 11.8 mg g(-1) at an equilibrium concentration of 1.0 and 0.1 mg L(-1), respectively. The GFC-1.0 mm also showed equivalent As removal performance to READ, a commercial adsorbent with CeO(2) as the sole metal oxide component (about 81%), under both space velocities of 240 and 24 h(-1) in column tests. The cost for the manufacturing of GFC, however, is much lower since iron is the major metal component (about 80%). Energy dispersive X-ray microanalysis (EDX) results showed that As was distributed from the surface to the center of the GFC after the As(V) adsorption experiment, suggesting that nearly all active sites inside the GFC were available for the removal of As(V). The As(V) on the used GFC could be desorbed with an efficiency of 89% using 1.0 mol L(-1) sodium hydroxide, and the GFC after desorption showed similar As adsorption performance with the fresh GFC. In conclusion, the GFC consisting of 80% Fe and 20% Ce exhibited As removal performance equivalent to the commercial adsorbent consisting only of Ce. (C) 2010 Elsevier B.V. All rights reserved. |
| WOS记录号 | WOS:000280625500020 |
| 源URL | [http://ir.rcees.ac.cn/handle/311016/21274]  |
| 专题 | 生态环境研究中心_环境水质学国家重点实验室 |
| 推荐引用方式 GB/T 7714 | Zhang, Yu,Dou, Xiaomin,Zhao, Bei,et al. Removal of arsenic by a granular Fe-Ce oxide adsorbent: Fabrication conditions and performance[J]. CHEMICAL ENGINEERING JOURNAL,2010,162(1):164-170. |
| APA | Zhang, Yu,Dou, Xiaomin,Zhao, Bei,Yang, Min,Takayama, Tomoo,&Kato, Shigeru.(2010).Removal of arsenic by a granular Fe-Ce oxide adsorbent: Fabrication conditions and performance.CHEMICAL ENGINEERING JOURNAL,162(1),164-170. |
| MLA | Zhang, Yu,et al."Removal of arsenic by a granular Fe-Ce oxide adsorbent: Fabrication conditions and performance".CHEMICAL ENGINEERING JOURNAL 162.1(2010):164-170. |
入库方式： OAI收割
来源：生态环境研究中心
浏览0
下载0
收藏0
其他版本
除非特别说明，本系统中所有内容都受版权保护，并保留所有权利。