中国科学院机构知识库网格系统: 检索

Modelling and performance analysis of power system in gas engine-driven heat pump 期刊论文 OAI收割
APPLIED THERMAL ENGINEERING, 2023, 卷号: 223, 页码: 15
作者: Tian, Jiayao; Hu, Yafei; Lv, Jie; Feng, Ziping; Song, Wenji

|

收藏 | 浏览/下载：7/0 | 提交时间：2025/11/14

Gas engine-driven heat pump Power system A general method Dynamic quantitative analysis Waste heat recovery Exergy and mechanical efficiency

The application of adaptive enhancement algorithm based on gray entropy in mammary gland CR image (EI CONFERENCE) 会议论文 OAI收割
2012 2nd International Conference on Consumer Electronics, Communications and Networks, CECNet 2012, April 21, 2012 - April 23, 2012, Three Gorges, China
Zhang M.-H.; Zhang Y.-Y.

收藏 | 浏览/下载：50/0 | 提交时间：2013/03/25

Mammary gland is composed entirely of soft tissue with approximate density therefore mammary gland CR medicine radiation image presents a low contrast and slight difference changes may be a manifestation of tumor so it is necessary to enhance mammary gland CR image to improve its visual quality in order to meet the demands of doctor's clinical diagnosis. However the general enhancement algorithms over enhance the contrast and noise due to image details lost aiming at the defects a mammary gland CR medicine image adaptive enhancement arithmetic based on image gray entropy is put forward. The arithmetic adapts dizzy image to magnify selected spatial frequency response in order to enhance the edge details of mammary gland CR images. It can adjust weighted factor K according to image gray characteristics namely pixel gray entropy. Experiments results demonstrate that mammary gland CR image enhanced by the algorithm has abundant details and high signal-to-noise ratio moreover CR image enhanced has good visual effect. So the method is effective and fit for enhancing CR medical radiation image edge details. 2012 IEEE.

Application of adaptive enhancement means in head and neck CR image (EI CONFERENCE) 会议论文 OAI收割
2012 3rd International Conference on Information Technology for Manufacturing Systems, ITMS 2012, September 8, 2012 - September 9, 2012, Qingdao, China
Zhang M.-H.; Zhang Y.-Y.

收藏 | 浏览/下载：60/0 | 提交时间：2013/03/25

Digital CR of head and neck overcomes the disadvantage of regular X-ray radiography which can not reveal bone and soft tissue position deficiency in one exposing and reduces the Xray radiation dose. Meanwhile various factors cause the decline of image quality and images must be enhanced in order to meet demands of doctor's clinical diagnosis. The general enhancement algorithms don't consider body's structure differences and density characteristics. A new adaptive CR enhancement algorithm was proposed in this article and head and neck CR images were processed with this method and compared with linear unsharp masking method. The experiment proves that the details of CR image enhanced were abundant and enhanced CR image had good visual effect SNR was high as well as detail variance /background variance (DV/BV) indicating that this algorithm is suitable for head and neck CR medical images. (2012) Trans Tech Publications Switzerland.

Tracking error modeling of the theodolite based on GRNN method (EI CONFERENCE) 会议论文 OAI收割
2nd International Conference on Frontiers of Manufacturing and Design Science, ICFMD 2011, December 11, 2011 - December 13, 2011, Taichung, Taiwan
作者: Li M.

收藏 | 浏览/下载：39/0 | 提交时间：2013/03/25

To meet the requirement of high tracking accuracy as well as develop more reasonable evaluation method in this paper the General Regression Neural Network (GRNN) has been applied to build the tracking error model of the theodolite. First we analyze the nonlinear factors in the theodolite. Second we discuss the principle of GRNN including its structure the function as well as its priors. Third we build the tracking error model based on GRNN and verify the model through the different parameters. The result indicated that the network model based on GRNN has high accuracy and good generalization ability. It could instead the real system to a certain extent. The research in this paper has important value to the engineering practice.

An efficient color transfer algorithm for recoloring multiband night vision imagery (EI CONFERENCE) 会议论文 OAI收割
Enhanced and Synthetic Vision 2010, April 6, 2010 - April 6, 2010, Orlando, FL, United states
作者: Xu S.

收藏 | 浏览/下载：41/0 | 提交时间：2013/03/25

A color transfer method is presented to give fused multiband nighttime imagery a natural daytime color appearance in a simple and efficient way. Instead of using the traditional nonlinear l space the proposed method transfers the color distribution of the target image (daylight color image) to the source image (fused multiband nighttime imagery) in the linear YCBCR color space. The YCBCR transformation is simpler and more suitable for image fusion compared to the l conversion. The YCBCR transformation can be extended into a general formalism. And the paper mathematically proves that for color transfer using color spaces conforming to this general YC BCR space framework can produce same recoloring results as using the YCBCR space. Experimental results demonstrate that the YCBCR based color transfer method works surprisingly well for transferring natural color characteristics of daylight color images to false color fused multiband nighttime imagery and moreover can also be successfully applied to recoloring a variety of color images. 2010 SPIE.

Using bidirectional binary particle swarm optimization for feature selection in feature-level fusion recognition system (EI CONFERENCE) 会议论文 OAI收割
2009 4th IEEE Conference on Industrial Electronics and Applications, ICIEA 2009, May 25, 2009 - May 27, 2009, Xi'an, China
作者: Wang D.; Wang Y.

收藏 | 浏览/下载：37/0 | 提交时间：2013/03/25

In feature-level fusion recognition system the other is optimizing system sensor design to get outstanding cost performance. So feature selection become usually necessary to reduce dimensionality of the combination of multi-sensor features and improve system performance in system design. In general there are two main missions. One is improving the recognition correct rate as soon as possible the optimization is usually applied to feature selection because of its computational feasibility and validity. For further improving recognition accuracy and reducing selected feature dimensions this paper presents a more rational and accurate optimization Bidirectional Binary Particle Swarm Optimization (BBPSO) algorithm for feature selection in feature-level fusion target recognition system. In addition we introduce a new evaluating function as criterion function in BBPSO feature selection method. At the last we utilized Leave-One-Out method to validate the proposed method. The experiment results show that the proposed algorithm improves classification accuracy by two percentage points while the selected feature dimensions are less one dimension than original Particle Swarm Optimization approach with 16 original feature dimensions. 2009 IEEE.

The calibration of faint simulation star magnitude based on single photon count technique (EI CONFERENCE) 会议论文 OAI收割
International Symposium on Photoelectronic Detection and Imaging 2009: Advances in Imaging Detectors and Applications, June 17, 2009 - June 19, 2009, Beijing, China
作者: Xu S.-Y.; Guo J.; Guo J.

收藏 | 浏览/下载：47/0 | 提交时间：2013/03/25

A calibration method of faint star magnitude of the star scene simulation device is proposed in this paper. In the research of simulation star magnitude luminometers and CCD devices are the general calibration devices which are used to measure the illumination intensity and calibrate its magnitude. But if the simulation magnitude is only sixth magnitude its illumination intensity is only 1.010-8 Lux. This illumination intensity level is the lowest illumination intensity that the commercial luminometer can detect. Hence the simulation star magnitude lower than six magnitude cannot be calibrated by luminoters. Likewise CCD devices also need an additive cooler in this case. When the single photon characteristic is presented due to the low luminosity of simulating light sources the simulation star magnitude can be calibrated by detecting its photon flux of radiation with the method of single photon count. In this paper the detection principle of single photon based on a compact designed PMT detecting of the radiation level of simulation star magnitude is advanced. Especially a spectrum match method is proved theoretically to be an effective means for selecting PMT photosensitive type. In the case of the detection object of the simulation star in visible wavelength a analysis indicates that the material of tri-alkali cathode materials its best choice after being compared the Signal-to-Noise of photon detector of several PMT photosensitive materials based on the different spectrum match ratio of different object light sources and different cathode materials. An experiment is employed to show the relationship of control voltage of PMT and its dark counter the relationship of the environment temperature of PMT and its dark counter which proves its only decades of CPS at room temperature. The so low dark counter avoids a bulky cooler and is convenient for installing it on the star scene simulation equipment. Finally in the experiment of calibrating the simulation star magnitudes the ability of its calibration is confirmed to reaches up to 12m meanwhile its calibration error is within 0.2m. 2009 SPIE.

An efficient discrete particle swarm algorithm for task assignment problems (EI CONFERENCE) 会议论文 OAI收割
2009 IEEE International Conference on Granular Computing, GRC 2009, August 17, 2009 - August 19, 2009, Nanchang, China
作者: Wang C.

收藏 | 浏览/下载：27/0 | 提交时间：2013/03/25

Task Assignment Problems (TAPs) in distributed computer system are general NP-hard and usually modeled as integer programming discrete problems. Many algorithms are proposed to resolve those problems. Discrete particle swarm algorithm (DPS) is a newly developed method to solve constraint satisfaction problem (CSP) which has advantage on search capacity and can find more solutions. We proposed an improved DPS to solve TAP in this paper. DPS has a special operator namely coefficient multiplying speed which is designed for CSP but does not exist in other discrete problems. Thus we redefined a coefficient multiplying speed operator with probability selection. We analyzed the speed and position updating formula then we derived a refined position updating formula. Several experiments are carried out to test our DPS. Experimental results show that our algorithm has more efficient search capacity higher success rate less running time and more robust.

Improved best tradeoff for high-resolution image fusion based on spectral reflection function 会议论文 OAI收割
International Conference on Earth Observation Data Processing and Analysis, ICEODPA,, Wuhan, China, December 28, 2008 - December 30,2008
Wang, Zhongwu; Zhao, Zhongming

收藏 | 浏览/下载：46/0 | 提交时间：2014/12/07

This paper extended the best tradeoff fast intensity-hue-saturation (BTFIHS) fusion to a more general model. Firstly based-on the methods proposed by previous researches we integrated injecting strategy of spatial detail information into the fusion model and also adopted the idea of BTFIHS to keep the intensity unchanged with the corresponding pixel in panchromatic (PAN) image while the hue and saturation of every pixel using BTFIHS were equal to them using tradeoff fast intensity-hue-saturation (TFIHS). Then we got a general formula of the improved best tradeoff for high-resolution image fusion based-on getting injecting parameter by spectral reflection function (SRF). At last several experiments were carried on to analysis and discuss the quality of the new methods compared with their originals. Results show that the new method could yield a "true" high-resolution multispectral (MS) image with vast improvement in blue band and nearly 3.3% improvement in Q4 for all bands. 2008 SPIE.

Design and analysis of large spaceborne light-weighted primary mirror and its support system (EI CONFERENCE) 会议论文 OAI收割
3rd International Symposium on Advanced Optical Manufacturing and Testing Technologies, AOMATT 2007: Large Mirrors and Telescopes, July 8, 2007 - July 12, 2007, Chengdu, China
Yan Y.; Jin G.; Yang H.-B.

收藏 | 浏览/下载：40/0 | 提交时间：2013/03/25

With the development of the resolution of spaceborne remote sensor the diameter of the primary mirror of spaceborne telescope becomes larger and larger. The distortion of primary mirror which is influenced by the mirror material structure self-weight support system and temperature environment affects optical image quality finally. In this paper an on-axis TMA high-resolution Cassegrain optical payload with a primary mirror whose diameter is 650mm was designed and the effects of the influence factors of the distortion acts on the on-axis TMA optical system primary mirror had been analyzed by means of Finite Element Analysis. During work the technology of the primary mirror design had been summarized and general consideration of the primary mirror design technology also had been described at the same time. Considering the telescope manufacture and work station a reasonable and optimal structure of the primary mirror sub-assembly is taken finally. In the end the distortion of the primary mirror during its fabrication station and work station had been analyzed by integrated Finite Element Analysis Method. The results implicated the synthesis profile error (P-V value) for the primary mirror is less than /10 and all the indexes of the primary mirror satisfy the requirements of the optical system.