中国科学院机构知识库网格系统: 检索

浏览/检索结果: 共4条，第1-4条

帮助

条数/页：排序方式：
	Tribological properties of Mos2 thin coatings under liquid lubricating (EI CONFERENCE) 会议论文 OAI收割 2nd International Conference on Innovation Manufacturing and Engineering Management, IMEM 2012, December 14, 2012 - December 16, 2012, Chongqing, China Bai Y.; Cao P. 收藏 \| 浏览/下载：33/0 \| 提交时间：2013/03/25 The objective of this study is to investigate the effect of solid and liquid lubrication on friction and wear performance of selected solid lubricating coatings comparative experiments have been carried out on magnetron sputtered MoS2 coatings against Si3N4 ball using a ball-on-disk tribo-tester under the conditions of room temperature and different lubrication. Surface morphology of coatings were investigated by atom force microscope (AFM) and friction coefficient (COF) and wear rate of solid films were also be analyzed. It was shown that the friction is greatly reduced when the solid film is lubricated with oil and grease simultaneously in comparison with single-lubricant lubrication at the start-up or under boundary lubrication conditions. Liquid lubrication causes a dramatic decrease of the wear-ability of the MoS2 coatings. The effect of oil lubrication to the deterioration of wear resistance of MoS2 film was even worse than lubrication grease. (2013) Trans Tech Publications Switzerland.
	Input plane preprocessing of joint transform correlator based on Swarm Intelligence (EI CONFERENCE) 会议论文 OAI收割 2009 2nd International Congress on Image and Signal Processing, CISP'09, October 17, 2009 - October 19, 2009, Tianjin, China Yong W.; Ming Z. 收藏 \| 浏览/下载：23/0 \| 提交时间：2013/03/25 Input plane image preprocessing can improve the performance of Joint Transform Correlator(JTC). Swarm Intelligence based image processing method is consistent with the parallel characteristic of optical signal processing method. In this paper A Swarm Intelligence based input plane preprocessing method is proposed. Some other methods are also used to perform the task such as grayscale transform Sobel operator and mathematical morphology. The experimental results show that the performance of the proposed Swarm Intelligence preprocessing based JTC is better than that of the JTC based on other preprocessing methods. 2009 IEEE.
	The synthesis and field emission property of carbon nanotubes on carbon fibers substrate (EI CONFERENCE) 会议论文 OAI收割 Technical Digest of the 20th International Vacuum Nanoelectronics Conference, IVNC 07, July 8, 2008 - July 12, 2008, Chicago, IL, United states Leyong Z.; Weibiao W.; Jingqiu L.; Yuxue X.; Da L.; Song C.; Haifeng Z. 收藏 \| 浏览/下载：33/0 \| 提交时间：2013/03/25 Using ferrocene as catalyst precursor C2H2 as carbon source carbon nanotubes (CNTs) with uniform density were synthesized on carbon fibers substrate by floating catalyst method. The morphology and microstructure were characterized by field emission scanning electron microscope (FESEM) and high-resolution transmission electron microscopy (HRTEM). The observation showed that the length of CNTs is about 2 m the average space between adjacent CNTs is about 300 nm and the diameter of CNT is about 45 nm. The less dense "short and stubby" aligned CNTs films should have good electron field emission characteristics. The results of field emission showed that the emission current of CNTs/carbon fibers was 5 A at the field of 2.5 V/m and the emission current can be 280 A with a field of 7 V/m (the specimen area is 0.25 cm2 and the distance between cathode and anode is 200 m). The calculation based on the F-N plot indicated that the field enhancement factor of CNTs tip is 499122. Using the conductivity and chemical stability of carbon fibers and the uniform and sparse density distribution of CNTs on carbon fibers substrate the tip predominance of carbon nanotubes can be exerted and simultaneously the effect of screening effects between adjacent carbon nanotubes on the field emission performance can also be effectively decreased. The CNTs synthesized on carbon fibers substrate has many predominances for the fabrication of cold cathode devices. For example using the removability of carbon fibers the cathode of CNTs/carbon fibers can be arbitrarily moved enlaced or combined to form different patterns and the cathode of CNTs/carbon fibers can be also fabricated in large size. Therefore CNTs/carbon fibers may have potential application in field emission displays.
	Studies on the morphology and crystallization behavior of PTT/PET blend systems 期刊论文 OAI收割 ACTA POLYMERICA SINICA, 2005, 期号: 5, 页码: 736-739 作者: Li, G; Dai, GX; Li, Y; Lu, KX; Chen, YM \| 收藏 \| 浏览/下载：20/0 \| 提交时间：2019/04/09 Poly(Ethylene Terephthalate) (Pet) Poly (Trimethylene Terephthalate) (Ptt) Blend Morphology And Performance