机构

• 力学研究所 [1]
• 长春光学精密机械与物... [1]

采集方式

• OAI收割 [2]

内容类型

• 会议论文 [1]
• 期刊论文 [1]

发表日期

• 2016 [1]
• 2012 [1]

学科主题

筛选

浏览/检索结果: 共2条，第1-2条 帮助 条数/页： 5101520253035404550556065707580859095100 排序方式： 请选择题名升序题名降序提交时间升序提交时间降序作者升序作者降序发表日期升序发表日期降序 裂隙岩体注浆扩散范围及注浆量数值模拟 期刊论文  OAI收割 煤炭学报, 2016, 卷号: 41, 期号: 10, 页码: 2588-2595 作者:  王强;  冯志强;  王理想;  唐德泓;  冯春 收藏  |  浏览/下载：56/0  |  提交时间：2017/02/24 grouting radius  grout quantity  discrete fracture network (DFN)  fractured rock masses  cell-centered finite volume method  multi-parameter study   Determination of optimum process parameters in gas-assisted injection molding (EI CONFERENCE) 会议论文  OAI收割 2011 International Conference on Electrical Information and Mechatronics, ICEIM2011, December 23, 2011 - December 25, 2011, Jiaozuo, China Zi K.; Chen L. 收藏  |  浏览/下载：20/0  |  提交时间：2013/03/25 With finite element analysis software Moldflow  numerical simulation and studies about FM truck roof handle were conducted on gas-assisted injection molding process. The influences of melt pre-injection shot  gas pressure  delay time and melt temperature were observed by using multi-factor orthogonal experimental method. According to the analysis of the factors' impact on evaluation index  the optimized parameter combination is obtained. Therefore the optimization design of technological parameters is done. The results show that during the gas-assisted injection molding  optimum pre-injection shot is 94%  gas pressure is 15MPa  delay time is 0.5s  melt temperature is 240 C. This study provided a more practical approach for the gas-assisted injection molding process optimization.