中国科学院机构知识库网格系统: 检索

浏览/检索结果: 共5条，第1-5条

帮助

条数/页：排序方式：
	Modeling and Optimization of Low-Power AND Gates Based on Stochastic Thermodynamics 期刊论文 OAI收割 IEEE TRANSACTIONS ON CIRCUITS AND SYSTEMS II-EXPRESS BRIEFS, 2022, 卷号: 69, 期号: 9, 页码: 3729-3733 作者: Kuang, Jiayue; Ge, Xiaohu; Yang, Yang; Tian, Lin \| 收藏 \| 浏览/下载：38/0 \| 提交时间：2022/12/07 Logic gates Transistors Energy states Thermodynamics Voltage Energy consumption Integrated circuit modeling Stochastic thermodynamics subthreshold voltage single-electron transistor AND gate order of operations
	Aircraft landing gear simulation using multidomain modeling technology (EI CONFERENCE) 会议论文 OAI收割 2011 International Conference on Information Technology, Computer Engineering and Management Sciences, ICM 2011, September 24, 2011 - September 25, 2011, Nanjing, Jiangsu, China 作者: Li M. 收藏 \| 浏览/下载：40/0 \| 提交时间：2013/03/25 In order to accurately analyze the performance and influence of landing gear system this paper presents a high fidelity plant model of an aircraft landing gear to inclusion into a full aircraft flight simulation. The use of domain specific modeling software enables detailed modeling of the physics and facilitates accurate computational simulation of the flight dynamic aerodynamic landing gear dynamic and mechanical loads that occur when the landing gear are deployed and retracted during landing and take-off operations. The parameter design space is easily searched by considering a number of different landing scenarios including touching down on one wheel first to optimize the design. The simulation results show that the aircraft landing gear system mathematical model established appropriately reflects the change of force and moment in the process of taking off and landing and it is improve the precision of flight simulation. 2011 IEEE.
	A real-time two-dimensional correlation speed measurement based on image (EI CONFERENCE) 会议论文 OAI收割 2010 International Conference on Computer, Mechatronics, Control and Electronic Engineering, CMCE 2010, August 24, 2010 - August 26, 2010, Changchun, China 作者: Yu L. 收藏 \| 浏览/下载：23/0 \| 提交时间：2013/03/25 In order to implement two-dimensional moving object's non-contact and real-time speed measurement in this paper wc proposed a new method which was based on the characteristic of FPGA and a real-time two-dimensional correlation speed measurement was proposed on image processing using high speed CMOS shown in figure 1. Experimental installation was shown in figure 2 a cardboard with images which was fixed in electric control movement device was moving to simulate moving object the CMOS image sensor gathered image signals of the cardboard and the image signals was output to FPGA after a serials pretreatment such as binaryzation etc. Logical operation insteaded mathematical operation on FPGA to implement two frames image's cross-correlation operations as the formula (10) in this paper and finally calculate the two-dimensional velocity. Through experiment result of table 1 we drawn an conclusion the accurarcy of the method in this paper was less than 1 pixel and the method can be used at a certain speed ranges of two-dimensional real-time speed measurement. 2010 IEEE.
	OFDM baseband modulation technology based on VHDL (EI CONFERENCE) 会议论文 OAI收割 2010 IEEE International Conference on Advanced Computer Control, ICACC 2010, March 27, 2010 - March 29, 2010, 445 Hoes Lane - P.O.Box 1331, Piscataway, NJ 08855-1331, United States Lin L.; Qiao Y.-F.; Su W.-X. 收藏 \| 浏览/下载：16/0 \| 提交时间：2013/03/25 In order to improve the transmission velocity in mulitipath fading wireless channel two main advantages are obtained via discussing spectrum utilization ratio of OFDM. Then the high speed OFDM technology receives increasing attentions in mobile communication. Modulation programs are designed with VHDL based on the principle of OFDM in the paper. First from the results of VHDL simulation after OFDM fundamental is introduced the realization of baseband operations such as interleaver subcarrier modulation IFFT and adding CP are presented. Finally implemented programs are validated on the actual implement system. Experimental results indicate that setup time corresponding to transmission velocity is only 71.05s and steady time is approximately 6 times as setup time that is not only achieving the high speed transmission but also supplying adequate modulation time. 2010 IEEE.
	Parameter identification of airborne vibrated image based on high-speed CCD (EI CONFERENCE) 会议论文 OAI收割 2010 International Conference on Computer, Mechatronics, Control and Electronic Engineering, CMCE 2010, August 24, 2010 - August 26, 2010, Changchun, China Shi J.; Xue X.; Guo Y. 收藏 \| 浏览/下载：33/0 \| 提交时间：2013/03/25 In order to identify the vibration parameters of a vibrated image the principle and shortage of the traditional methods that based on image derivative and image transformation are analyzed and a new parameter identification method is proposed afterward. By placing a high-speed CCD aside the master CCD the vibration can be sampled accurately and more information can be obtained for parameter identification. The series frames that captured by high-speed CCD are processed by gray projection algorithm and the vibration extents between adjacent frames along x and y direction are obtained. By using simple triangle operations the vibration parameters can be identified and the computational complexity of which can be reduced greatly. The experiment shows that the parameter identification method based on high-speed CCD can identify the parameters of vibration with any form accurately. The precise of parameter identification for linear vibration is less than 2.95%. 2010 IEEE.