中国科学院机构知识库网格
Chinese Academy of Sciences Institutional Repositories Grid
Properties of al(2)o(3)-40 wt.% zro(2) composite coatings from ultra-fine feedstocks by atmospheric plasma spraying

文献类型:期刊论文

作者Zhao, Xiaoqin1,2; An, Yulong1,2; Chen, Jianmin1; Zhou, Huidi1; Yin, Bin1,2
刊名Wear
出版日期2008-11-26
卷号265期号:11-12页码:1642-1648
关键词Al(2)o(3)-zro(2) composite coating Plasma spraying Microstructure Friction and wear behavior Wear mechanism
ISSN号0043-1648
DOI10.1016/j.wear.2008.03.019
通讯作者Chen, jianmin(chenjm@lzb.ac.cn)
英文摘要In the present study, both ultra-fine and coarse al(2)o(3)-40 wt.% zro(2) grains were used as the starting materials to prepare ultra-fine structured and micro-structured al(2)o(3)-40 wt.% zro(2) composite coatings (coded as nzta coating and mzta coating, respectively) by atmospheric plasma spraying. the ultra-fine al(2)o(3)-40 wt.% zro(2) feedstocks for spraying were prepared by means of crushing sintered, starting from commercially availed powders of ultra-fine al(2)o(3) and zro(2). the microstructures and phase compositions of the crushing sintered powders and the corresponding composites coatings were investigated by means of scanning electron microscopy (sem) and x-ray diffraction (xrd). the friction and wear behaviors of the composites coatings sliding against stainless-steel under dry friction conditions and at room temperature were investigated using an optimol srv oscillating friction and wear tester. the wear mechanisms of the coatings were discussed based on the sem observation of the worn surface morphologies and wear debris, and the elemental composition analysis of the wear debris by energy dispersive x-ray analysis as well. results showed that aside from the typical splat lamellae, equiaxle grains were also observed in the al(2)o(3)-40 wt.% zro(2) composite coating made from the corresponding ultra-fine crushing sintered powders. the nzta coatings had higher microhardness and better wear resistance than that of the mzta coatings, which could be largely attributed to the better inter-splats bonding of the former. and the stainless-steel counterpart matched with the nzta coatings had a smaller wear rate as well. moreover, the two types of composites coatings were dominated by spalling and fracture as sliding against the stainless-steel counterpart, and the mzta coatings experienced more severe worn surface damage at a larger load than the nzta coatings tested under the same conditions, well corresponding to the difference in the wear resistance of the two types of composite coatings. (c) 2008 elsevier b.v. all rights reserved.
WOS关键词TRIBOLOGICAL PROPERTIES ; SLIDING WEAR ; WC-CO ; BEHAVIOR ; CERAMICS
WOS研究方向Engineering ; Materials Science
WOS类目Engineering, Mechanical ; Materials Science, Multidisciplinary
语种英语
WOS记录号WOS:000261283300010
出版者ELSEVIER SCIENCE SA
URI标识http://www.irgrid.ac.cn/handle/1471x/2391406
专题中国科学院大学
通讯作者Chen, Jianmin
作者单位1.Chinese Acad Sci, Lanzhou Inst Chem Phys, State Key Lab Solid Lubricat, Lanzhou 730000, Peoples R China
2.Chinese Acad Sci, Grad Sch, Beijing 100049, Peoples R China
推荐引用方式
GB/T 7714
Zhao, Xiaoqin,An, Yulong,Chen, Jianmin,et al. Properties of al(2)o(3)-40 wt.% zro(2) composite coatings from ultra-fine feedstocks by atmospheric plasma spraying[J]. Wear,2008,265(11-12):1642-1648.
APA Zhao, Xiaoqin,An, Yulong,Chen, Jianmin,Zhou, Huidi,&Yin, Bin.(2008).Properties of al(2)o(3)-40 wt.% zro(2) composite coatings from ultra-fine feedstocks by atmospheric plasma spraying.Wear,265(11-12),1642-1648.
MLA Zhao, Xiaoqin,et al."Properties of al(2)o(3)-40 wt.% zro(2) composite coatings from ultra-fine feedstocks by atmospheric plasma spraying".Wear 265.11-12(2008):1642-1648.

入库方式: iSwitch采集

来源:中国科学院大学

浏览0
下载0
收藏0
其他版本

除非特别说明,本系统中所有内容都受版权保护,并保留所有权利。