中国科学院机构知识库网格系统: 检索

Coefficient of performance and its bounds of minimally nonlinear irreversible refrigerator at arbitrary optimal value 期刊论文 OAI收割
MODERN PHYSICS LETTERS B, 2018, 卷号: 32, 期号: 20, 页码: 1850232
作者: Zhang, M; Liu, Q; He, JZ; Wang, JH

|

收藏 | 浏览/下载：38/0 | 提交时间：2018/12/27

MAXIMUM POWER OUTPUT EFFICIENCY OPTIMIZATION ENGINE CYCLES

Validity of a Newly-Designed Rectilinear Stepping Ergometer Submaximal Exercise Test to Assess Cardiorespiratory Fitness 期刊论文 OAI收割
JOURNAL OF SPORTS SCIENCE AND MEDICINE, 2017, 卷号: 16, 期号: 3, 页码: 357-364
作者: Zhang, Rubin

|

收藏 | 浏览/下载：21/0 | 提交时间：2018/08/16

Maximum Oxygen Uptake Metabolic Equation Rectilinear Reciprocating Motion Constant Power Output

Effects of critical and boiling temperatures on system performance and fluid selection indicator for low temperature organic rankine cycles 期刊论文 iSwitch采集
Energy, 2016, 卷号: 109, 页码: 830-844
作者: Yang, Lixiang; Gong, Maoqiong; Guo, Hao; Dong, Xueqiang; Shen, Jun

收藏 | 浏览/下载：39/0 | 提交时间：2019/05/09

Orc Critical temperature Boiling temperature Maximum net output power Vapor expansion ratio

Weighted reciprocal of temperature, weighted thermal flux, and their applications in finite-time thermodynamics 期刊论文 OAI收割
PHYSICAL REVIEW E, 2014, 卷号: 89, 期号: 1, 页码: 12129
Sheng, SQ; Tu, ZC

收藏 | 浏览/下载：23/0 | 提交时间：2014/04/25

MAXIMUM POWER OUTPUT HEAT-TRANSFER LAW REFRIGERATION CYCLES SOLVABLE MODEL OPTIMAL PATHS EFFICIENCY ENGINES PERFORMANCE RATCHET SYSTEMS

Design of driving circuit for binocular CCD image system (EI CONFERENCE) 会议论文 OAI收割
5th International Symposium on Advanced Optical Manufacturing and Testing Technologies: Optoelectronic Materials and Devices for Detector, Imager, Display, and Energy Conversion Technology, April 26, 2010 - April 29, 2010, Dalian, China
作者: Zhang X.; Zhang X.; Zhang X.

收藏 | 浏览/下载：42/0 | 提交时间：2013/03/25

The paper designs a driving circuit of high sensitive wide dynamic and high signal-to-noise ratio for binocular CCD imaging system which adopts a Dalsa-made high resolution full-frame 33-mega pixels area CCD FTF5066M. Inner structure and driving timing of the FTF5066M sensor are presented. Field Programmable Gate Array (FPGA) is used as the main device to accomplish the timing design of the circuits and power driver control of the two sensors. By using the Correlated Double Sampling (CDS) technique the video noise is reduced and the SNR of the system is increased. A 12- bit A/D converter is used to improve the image quality. The output rate of the imaging system designed with integrated chip can reach to 1.3 frames per second through bi-channel. For its good performance low power consumption and small volume the driving system can be applied to aeronautics and astronautics field. With a further improvement a maximum data output rate of 2.7 frames per second can be reached through all the eight channels of the two CCDs. 2010 Copyright SPIE - The International Society for Optical Engineering.

Design and analysis of power system of micro-electromechanical actuator (EI CONFERENCE) 会议论文 OAI收割
2010 2nd International Conference on Industrial Mechatronics and Automation, ICIMA 2010, May 30, 2010 - May 31, 2010, Wuhan, China
作者: Zhang J.; Zhang J.; Zhang J.

收藏 | 浏览/下载：23/0 | 提交时间：2013/03/25

In order to apply the electromechanical actuator to tactical mini-missiles maximum rotational speed of output shafts is greater than 250/s. Test results basically correspond to the requirement of technical indexes. It is proved that this analysis and design method is congruent with the design of micro-electromechanical actuators this paper researches on the key technology such as load-bearing ability the system bandwidth can reach 25.3Hz on the condition of no load and 23.4Hz on the condition of load thus the method is feasible. 2010 IEEE. rapidity and miniaturization of the micro-electromechanical actuator power system based on the ball screw. First according to specific technical indexes the power electromechanical time constant and the size of the motors are screened originally through theoretical analysis. Finally based on the characteristics of ball screw transmission load locus of the micro-electromechanical actuator dynamic system is theoretically analyzed and the optimum speed ratio is determined through parameter optimization. The results of the double closed loop controlled test on the principle prototype show: the system can operate normally with 2.5N.m hinge moment

Temperature characteristics of high power vertical cavity surface emitting lasers (EI CONFERENCE) 会议论文 OAI收割
Semiconductor Lasers and Applications III, November 12, 2007 - November 13, 2007, Beijing, China
作者: Qin L.

收藏 | 浏览/下载：29/0 | 提交时间：2013/03/25

By using oxidation confinement technology high power vertical-cavity surface-emitting lasers are fabricated in experiment. The electrical and optical performance characteristics such as threshold current efficiency emission wavelength and output power are measured under continuous wave (CW) condition at room temperature. The maximum output power is up to watt regime at wavelength of about 980nm. The temperature characteristics of the device are investigated experimentally in detail. The variation in lasing threshold current with temperature is studied. The characteristic temperature T0 of the device is derived and the value is about 211K. Such a high characteristic temperature T0 of threshold current can lead to good temperature sensitivity of the device. At the same time the lasing spectrum characteristics with temperature are also measured. The wavelength shift with temperature is just about 0.06nm/K. From the measured results it is shown that the device can still operate at high temperature condition.

A novel bottom-emitting vcsel's one-dimension array (EI CONFERENCE) 会议论文 OAI收割
Optoelectronic Materials and Devices III, October 27, 2008 - October 30, 2008, Hangzhou, China
作者: Wang L.; Wang L.; Wang L.; Liu Y.; Liu Y.

收藏 | 浏览/下载：23/0 | 提交时间：2013/03/25

A novel 980nm bottom-emitting VCSELs array with high power density and good beam property of Gaussian far-field distribution is reported. This array is composed of 5 symmetrically-arranged elements of 200m 150m and 100m-diameter with the center spacings of 300m and 250m respectively. The maximum power is 880mW at a current of 4A corresponding to lKW/cm2 average optical power density. The differential resistance is 0.09 with a threshold of 0.56A. The novel array is compared with a 300m-aperture-size single device and a 44 2-D array with 50m element aperture size and 250m centre spacing. The three devices have the same lasing area. The conclusion is that the novel array is better in the property of output power threshold current lasing spectra far-field distribution etc. 2008 SPIE.

Large aperture low threshold current 980nmVCSELs fabricated with pulsed anodic oxidation (EI CONFERENCE) 会议论文 OAI收割
Optoelectronic Materials and Devices II, November 2, 2007 - November 5, 2007, Wuhan, China
Jinjiang C.; Yongqiang N.; Te L.; Guangyu L.; Yan Z.; Biao P.; Yanfang S.; Lijun W.

收藏 | 浏览/下载：26/0 | 提交时间：2013/03/25

Pulsed anodic oxidation technique a new way of forming current blocking layers was successfully used in ridge-waveguide QW laser fabrication. We apply this method in 980nm VCSELs fabrication to form a high-quality native oxide current blocking layer which simplify the device process. A significant reduction of threshold current and a distinguished device performance are achieved. The 500m-diameter device has a current threshold as low as 0.48W. The maximum CW operation output power at room temperature is 1.48W. The lateral divergence angle //and vertical divergence angle are as low as 15.3 and 13.8 without side-lobes at a current of 6A.

High power vertical cavity surface-emitting laser with high reliability (EI CONFERENCE) 会议论文 OAI收割
Optoelectronic Materials and Devices II, November 2, 2007 - November 5, 2007, Wuhan, China
Changling Y.; Guoguang L.; Chunfeng H.; Li Q.

收藏 | 浏览/下载：16/0 | 提交时间：2013/03/25

High-power vertical-cavity surface-emitting lasers with InGaAs/GaAs quantum well active gain region are investigated. By using AlAs oxidation technology the devices have been fabricated in experiment and the characteristics of the device are carried out at room temperature. The 300m-diameter VCSELs have the maximum room temperature continuous wave (CW) optical output power of about 1.1W and the threshold current of the device is about 0.46A. The life test of the device is carried out in constant current mode. The life test of 300-m diameter lasers shows that the average lifetime is about 1800h at 80C. The device degradation mechanism is also discussed in detail.