中国科学院机构知识库网格系统: 检索

浏览/检索结果: 共8条，第1-8条

帮助

条数/页：排序方式：
	Investigation on geothermal binary-flashing cycle employing zeotropic mixtures as working fluids 期刊论文 OAI收割 GEOTHERMAL ENERGY, 2019, 卷号: 7, 期号: 1, 页码: 16 作者: Wang, Lingbao; Bu, Xianbiao; Li, Huashan \| 收藏 \| 浏览/下载：36/0 \| 提交时间：2020/10/29 Binary-flashing cycle Zeotropic mixtures Geothermal energy R245fa R600 Optimum performance
	Performance characteristics and working fluid selection for low-temperature binary-flashing cycle 期刊论文 OAI收割 APPLIED THERMAL ENGINEERING, 2018, 卷号: 141, 页码: 51-60 作者: Liu, Xi; Li, Huashan; Bu, Xianbiao; Wang, Lingbao; Xie, Ning \| 收藏 \| 浏览/下载：19/0 \| 提交时间：2020/10/29 Low-temperature energy source Binary-flashing cycle Parameter analysis Optimum performance Working fluid selection
	Evaluation of pavement straw composite fiber on SMA pavement performances 期刊论文 OAI收割 CONSTRUCTION AND BUILDING MATERIALS, 2013, 卷号: 41, 页码: 834-843 作者: Xue Qiang; Feng Xia-ting; Liu Lei; Chen Yi-jun; Liu Xiao-li \| 收藏 \| 浏览/下载：19/0 \| 提交时间：2018/06/05 Asphalt pavement Pavement straw composite fibers Asphalt mixture The optimum content The first admixing technology Performance evaluation
	Optimum design of laser encoding and decoding on laser beam-riding guidance (EI CONFERENCE) 会议论文 OAI收割 2nd International Conference on Frontiers of Manufacturing and Design Science, ICFMD 2011, December 11, 2011 - December 13, 2011, Taichung, Taiwan 作者: Yang L.; Yang L. 收藏 \| 浏览/下载：37/0 \| 提交时间：2013/03/25 Operating principle of laser beam-riding guidance was set forth. Based on the principle of spatial frequency-encoding experimental results demonstrated that the receiver can receive correctly the encoded signal and can decode the signal an optimum laser encoding mode was designed measurement for the missdistance is feasible and all the performance parameters satisfy the demand. (2012) Trans Tech Publications which can transfer continuous laser into pulse laser that represents different position information. Then the mathematic model of deviation from target is built Switzerland. a modified encoding pattern was presented which is composed of two light paths crossed 90. Azimuth information of target is given in orthogonal coordinate system and deviation from target is linearity. As well as characteristic distribution of spatial laser field is analyzed. Corresponding decoding mode was presented by testing in 2 kilometers outdoor
	Fabrication of high-efficiency ultraviolet blazed gratings by use of direct Ar2-CHF3 ion-beam etching through a rectangular photoresist mask (EI CONFERENCE) 会议论文 OAI收割 International Symposium on Photoelectronic Detection and Imaging 2011: Sensor and Micromachined Optical Device Technologies, May 24, 2011 - May 26, 2011, Beijing, China Tan X. 收藏 \| 浏览/下载：26/0 \| 提交时间：2013/03/25 In ultraviolet spectroscopy groove irregularity and surface roughness of nanometer magnitude can cause a significant loss of diffraction efficiency. Therefore there is a constant need to improve the diffraction efficiency. A blazed grating can concentrate most of the light intensity into a desired diffraction order it is important to control the groove shape precisely so it is the optimum choice among gratings of different kinds of profile. As the operating wavelength of most UV spectral applications is less than 200 nm especially the blaze angle and the apical angle. We have presented a direct shaping method to fabricate EUV blazed gratings by using an ion-beam mixture of Ar+ and CHF2 +to etch K9 glass with a rectangular photoresist mask. With this method the required blaze angle is small we have succeeded in fabricating well-shaped UV blazed gratings with a 1200 line/mm groove density and 8.54 blaze angles and 1200 line/mm groove density and 11.68 blaze angles and the metrical efficiency is about 81% and 78%. The good performance of the gratings was verified by diffraction efficiency measurements. When one uses the etching model the conditions on the ion-beam grazing incident angle and the CHF3partial pressure should be noted. Besides since the etched groove shape depends on the aspect ratio of the photoresist mask ridge if we wish to fabricate larger gratings with this method we must improve the uniformity of the photoresist mask before ion-beam etching. 2011 Copyright Society of Photo-Optical Instrumentation Engineers (SPIE).
	Dynamic optimum design and analysis of cam wave generator for harmonic gear drive (EI CONFERENCE) 会议论文 OAI收割 2011 International Conference on Information and Automation, ICIA 2011, June 6, 2011 - June 8, 2011, Shenzhen, China Xiao Q.; Han X.; Jia H. 收藏 \| 浏览/下载：32/0 \| 提交时间：2013/03/25 Mathematical models of structural optimization were established for the cam wave generator then a conceptual model by integrally taking its static and dynamic performance into consideration which satisfied the model acted by four concentrated forces while the dynamic optimum design was carried out. The topology optimization of the cam wave generator was performed based on artificial material density method was obtained. And the size optimization of the cam wave generator was also executed based on the zero-order method in software Ansys after setting up its parameterized model. The optimized results indicate that its final volume declines to 1284.217mm3 from its 1397.830mm3 which reduced by 42.18% than the original volume of cam (2221.224mm3). Simultaneously the static analysis and modal analysis were implemented and the results show that the static and dynamic performance complies with the design requirements proving that the results of dynamic optimum design are reasonable. The optimized results in paper are realizable in engineering. And the study method provides not only a reference to decreasing design mass and lowering inertia of the cam wave generator but also an important basis of lightweight design of harmonic gear drive. 2011 IEEE.
	Real time tracking by LOPF algorithm with mixture model (EI CONFERENCE) 会议论文 OAI收割 MIPPR 2007: Automatic Target Recognition and Image Analysis; and Multispectral Image Acquisition, November 15, 2007 - November 17, 2007, Wuhan, China Meng B.; Zhu M.; Han G.; Wu Z. 收藏 \| 浏览/下载：31/0 \| 提交时间：2013/03/25 A new particle filter-the Local Optimum Particle Filter (LOPF) algorithm is presented for tracking object accurately and steadily in visual sequences in real time which is a challenge task in computer vision field. In order to using the particles efficiently we first use Sobel algorithm to extract the profile of the object. Then we employ a new Local Optimum algorithm to auto-initialize some certain number of particles from these edge points as centre of the particles. The main advantage we do this in stead of selecting particles randomly in conventional particle filter is that we can pay more attentions on these more important optimum candidates and reduce the unnecessary calculation on those negligible ones in addition we can overcome the conventional degeneracy phenomenon in a way and decrease the computational costs. Otherwise the threshold is a key factor that affecting the results very much. So here we adapt an adaptive threshold choosing method to get the optimal Sobel result. The dissimilarities between the target model and the target candidates are expressed by a metric derived from the Bhattacharyya coefficient. Here we use both the counter cue to select the particles and the color cur to describe the targets as the mixture target model. The effectiveness of our scheme is demonstrated by real visual tracking experiments. Results from simulations and experiments with real video data show the improved performance of the proposed algorithm when compared with that of the standard particle filter. The superior performance is evident when the target encountering the occlusion in real video where the standard particle filter usually fails.
	Effects of feeding rate on growth performance of white sturgeon (Acipenser transmontanus) larvae 期刊论文 OAI收割 AQUACULTURE, 2003, 卷号: 217, 期号: 1-4, 页码: 589-598 作者: Deng, DF; Koshio, S; Yokoyama, S; Bai, SC; Shao, QJ 收藏 \| 浏览/下载：31/1 \| 提交时间：2010/10/13 white sturgeon larvae optimum feeding rates growth performance body composition