中国科学院机构知识库网格系统: 检索

浏览/检索结果: 共7条，第1-7条

帮助

条数/页：排序方式：
	Linearity measurement for image-intensified CCD (EI CONFERENCE) 会议论文 OAI收割 5th International Symposium on Advanced Optical Manufacturing and Testing Technologies: Optical Test and Measurement Technology and Equipment, April 26, 2010 - April 29, 2010, Dalian, China 作者: Zhang L.; Zhao Y.; Zhao Y.; Zhao Y.; Yan F. 收藏 \| 浏览/下载：34/0 \| 提交时间：2013/03/25 To the characteristic of the ultraviolet CCD (UV ICCD) technique of the linearity measurement of the UV ICCD camera is studied based on the theory of radiometry. Approach of linearity measurement is discussed and a kind of measurement system of the UV ICCD has been developed based on the method of neutral density filter. It is very important that the transmittance of the filter is independent of the wavelength in the method of neutral density filter. Black metal screen mesh with different transmittance is used in our system and calibration of the filters' transmittance in different working positions has been done. Meanwhile to assure the uniform of the received radiation on the target of the detector at any test points an integrating sphere is placed behind the neutral filter to balance light. The whole measurement system mainly consists of a deuterium lamp with high stabilization the attenuation film with transmission integrating sphere optical guide and electro-shift platform. Auto control is realized via special software during the test. With this instrument the linearity of the UV ICCD was measured. Experimental results show that the nonlinearity of the UV ICCD under fixed-gain is less than 2% and the uncertainty of measurement system is less than 4%. 2010 Copyright SPIE - The International Society for Optical Engineering.
	Driving techniques for high frame rate CCD camera (EI CONFERENCE) 会议论文 OAI收割 Electronic Imaging and Multimedia Technology V, November 12, 2007 - November 15, 2007, Beijing, China Guo W.; Jin L.; Xiong J. 收藏 \| 浏览/下载：30/0 \| 提交时间：2013/03/25 This paper describes a high-frame rate CCD camera capable of operating at 100 frames/s. This camera utilizes Kodak KAI-0340 an interline transfer CCD with 640(vertical)480(horizontal) pixels. Two output ports are used to read out CCD data and pixel rates approaching 30 MHz. Because of its reduced effective opacity of vertical charge transfer registers interline transfer CCD can cause undesired image artifacts such as random white spots and smear generated in the registers. To increase frame rate a kind of speed-up structure has been incorporated inside KAI-0340 then it is vulnerable to a vertical stripe effect. The phenomena which mentioned above may severely impair the image quality. To solve these problems some electronic methods of eliminating these artifacts are adopted. Special clocking mode can dump the unwanted charge quickly then the fast readout of the images cleared of smear follows immediately. Amplifier is used to sense and correct delay mismatch between the dual phase vertical clock pulses the transition edges become close to coincident so vertical stripes disappear. Results obtained with the CCD camera are shown.
	Compressed infrared mirror-lens system design (EI CONFERENCE) 会议论文 OAI收割 International Symposium on Photoelectronic Detection and Imaging, ISPDI 2007: Optoelectronic System Design, Manufacturing, and Testings, September 9, 2007 - September 12, 2007, Beijing, China 作者: Jiang H. 收藏 \| 浏览/下载：11/0 \| 提交时间：2013/03/25 In the special optical system such as the infrared optical system the compressed construction and mini module is necessary. In this paper a kind of compressed infrared lens design is proposed. The total length and focus length ratio is no more than 0.6 and this type system is accessible of temperature the key step in this design is how to make the system actable. The parasitic light is also analyzed. The couple efficient of cool stop is 100%.
	Study on CCD image compression and mass storage (EI CONFERENCE) 会议论文 OAI收割 ICO20: Optical Information Processing, August 21, 2005 - August 26, 2005, Changchun, China 作者: Liu H.; Liu H.; Liu H. 收藏 \| 浏览/下载：30/0 \| 提交时间：2013/03/25 When CCD camera photographs massive images in the air it is very important to compress and save CCD image timely and validly. This paper designs the CCD image compression and mass storage system. The one part is image compression: this paper introduces a reduced memory still image compression algorithm based on Listless Zerotree Coding (LZC). Compared with SPIHT the approach significantly reduced memory requirement and no reducing the quality of the reconstructed image. The other part is image mass storage: this system uses a kind of special hard disk storage devices that can realize faster data transmission to SCSI (Small Computer System Interface) devices even if it separates oneself from PCs. In the faster data acquisition and storage system data storage is a key technology. Normal approach is saving the data to mass memories and then processing and saving the data after complete acquisition. The continuous acquisition time is restricted with the storage capacity in the normal method so that it can't receive the requirement of CCD image storage on many occasions. While its price will be geminate increasing when we increase the storage capacity. So the approach in this paper is better one to use fast disks on data direct mass storage considering the storage capacity read/write speed and unit cost. The result of the experiment shows that the system has compressed and saved CCD image validly so it reached the anticipative purpose.
	Dispersion compensating properties of microstructure fiber (EI CONFERENCE) 会议论文 OAI收割 ICO20: Optical Communication, August 21, 2005 - August 26, 2005, Changshun, China 作者: Li C.; Wang W.; Wang W.; Li C.; Li C. 收藏 \| 浏览/下载：27/0 \| 提交时间：2013/03/25 Microstructure fiber is a new kind of optical fiber. An arrangement of air holes running along the full length of the fiber provides the confinement and guidance of light. The light is confined in the silica core along the fiber axis. This fiber has endlessly single mode special dispersion characteristics and so on. Using a vectorial effective-index numerical method we investigated the dispersion characteristics of a microstructure fiber with honeycomb cladding structures. The dispersion dispersion slope and Kappa parameter can be designed neatly by changing the air hole size and the separation of the holes in fiber cladding. We demonstrated the Microstructure fiber with large absolute value of normal dispersion and negative dispersion slope at the wavelength of 1550nm. Conventional communication non-shifted single-mode fibers and nonzero-dispersion shifted fibers (NZ-DSF) can be compensated efficiently using the microstructure fiber at the wavelength around 1550nm.
	Packaging technology of polymer/Si arrayed waveguide grating and their environmental stability (EI CONFERENCE) 会议论文 OAI收割 2005 6th International Conference on Electronics Packaging Technology, August 30, 2005 - September 2, 2005, Dameisha, Shenzhen, China 作者: Zhang Y.; Zhang X.; Zhang X.; Zhang X.; Wang F. 收藏 \| 浏览/下载：30/0 \| 提交时间：2013/03/25 Future optical communication systems will use more of the exceptional high bandwidth of optical fiber. Wavelength division multiplexing (WDM) systems are well suited to transport terabits of information via the fiber[1]. Multiplexers/ demultiplexers (MUX/DEMUX) are essential components for dense WDM systems. Several different kinds of multiplexer types have been developed in the past: (a) interference filters (b) fiber gratings and (c) planar lightwave circuit (PLC) MUX/DEMUXers[2 3]. The planar fabrication process of the last mentioned PLCs allows the realization of high performance filters with a large number of wavelength channels. Further an integration with other optical elements seems to be possible. Arrayed waveguide gratings (AWG) are a special kind of PLC-MUX/DEMUXers which are very attractive components for WDM systems because of their great flexibility in filter design[4 5]. Basically an AWG is an optical spectrograph built in planar waveguide technique. Typically AWGs works in a high grating order (50-250). For AWG multiplexer applications in communications systems a precise wavelength controllability and wavelength stability with long term is demanded. Recently a polymeric (especially fluorinated polymer with low optical absorption loss in the infrared region) AWG has attracted much attention because of its easy fabrication low cost possibility and a potential of integration with other polymer devices[6]. Standard AWGs however show a change of center wavelength with temperature. A method to prevent this temperature drift is to package the AWG together with a temperature controller in order to tune and fix the desired filter-wavelength. In this paper a 32-channel AWG was fabricated using a cross-linkable fluorinated poly (ether ether ketone) (FPEEK) its package technology and environmental stability were also discussed. 2005 IEEE.
	Correlation function of Potts model on Bethe lattice 期刊论文 OAI收割 CHINESE PHYSICS LETTERS, 2000, 卷号: 17, 期号: 8, 页码: 549 Han, B; Chen, S 收藏 \| 浏览/下载：17/0 \| 提交时间：2013/09/17 CONFLUENT TRANSFER-MATRIX SIERPINSKI CARPETS SPECIAL KIND