中国科学院机构知识库网格系统: 检索

浏览/检索结果: 共7条，第1-7条

帮助

条数/页：排序方式：
	Design of driving circuit for binocular CCD image system (EI CONFERENCE) 会议论文 OAI收割 5th International Symposium on Advanced Optical Manufacturing and Testing Technologies: Optoelectronic Materials and Devices for Detector, Imager, Display, and Energy Conversion Technology, April 26, 2010 - April 29, 2010, Dalian, China 作者: Zhang X.; Zhang X.; Zhang X. 收藏 \| 浏览/下载：42/0 \| 提交时间：2013/03/25 The paper designs a driving circuit of high sensitive wide dynamic and high signal-to-noise ratio for binocular CCD imaging system which adopts a Dalsa-made high resolution full-frame 33-mega pixels area CCD FTF5066M. Inner structure and driving timing of the FTF5066M sensor are presented. Field Programmable Gate Array (FPGA) is used as the main device to accomplish the timing design of the circuits and power driver control of the two sensors. By using the Correlated Double Sampling (CDS) technique the video noise is reduced and the SNR of the system is increased. A 12- bit A/D converter is used to improve the image quality. The output rate of the imaging system designed with integrated chip can reach to 1.3 frames per second through bi-channel. For its good performance low power consumption and small volume the driving system can be applied to aeronautics and astronautics field. With a further improvement a maximum data output rate of 2.7 frames per second can be reached through all the eight channels of the two CCDs. 2010 Copyright SPIE - The International Society for Optical Engineering.
	Design of ground-based physical simulation system for satellite-borne TDI-CCD dynamic imaging (EI CONFERENCE) 会议论文 OAI收割 Optoelectronic Imaging and Multimedia Technology, October 18, 2010 - October 20, 2010, Beijing, China 作者: Zhang L.; Zhang L.; Sun Z. 收藏 \| 浏览/下载：24/0 \| 提交时间：2013/03/25 As we know the existence of image motion has a bad effect on the image quality of satellite-borne TDI CCD camera. Although many theories on image motion are proposed to cope with this problem few simulations are done to justify the proposed theories on ground. And thus in this paper a ground-based physical simulation system for TDI CCD imaging is developed and specified which consists of a physical simulation subsystem for precise satellite attitude control based on a 3-axis air bearing table and an imaging and simulation subsystem utilizing area-array CCD to simulate TDI CCD. The designed system could realize not only a precise simulation of satellite attitude control whose point accuracy is above 0.1 and steady accuracy above 0.01/s but also an imaging simulation of 16-stage TDI CCD with 0.1s its integration time. This paper also gives a mathematical model of image motion of this system analogous with satellite-borne TDI CCD and detailed descriptions on the principle utilizing area-array CCD to simulate TDI CCD. It is shown that experiment results are in accordance with mathematical simulation and that the image quality deteriorate seriously when the correspondence between the image velocity and signal charges transfer velocity is broken out which suggest not only the validity of the system design but also the validity of the proposed image motion theory of TDI CCD. 2010 SPIE.
	Driving and image enhancement for CCD sensing image system (EI CONFERENCE) 会议论文 OAI收割 2010 3rd IEEE International Conference on Computer Science and Information Technology, ICCSIT 2010, July 9, 2010 - July 11, 2010, Chengdu, China Zhang M.; Ren J. 收藏 \| 浏览/下载：27/0 \| 提交时间：2013/03/25 The paper designs a driving circuit of high sensitive wide dynamic for CCD sensing imaging system which adopts a Dalsa-made high resolution full-frame 33-mega pixels area CCD FTF5066M. Field Programmable Gate Array (FPGA) is used as the main device to accomplish the timing design of the circuits and power driver control of the sensor. By using the Correlated Double Sampling (CDS) technique the video noise is reduced and the SNR of the system is increased. The output rate of the imaging system designed with integrated chip can reach to 1.3 frames per second through bi-channel output. We use the histogram specification to adjust the brightness of the captured image. And then use the median filtering to suppress the noise. The traditional gray mean gradient (GMG) and the objective evaluation method based on Human Visual System (HVS) used to verify the effect of image enhancement. 2010 IEEE.
	Storage and compression design of high speed CCD (EI CONFERENCE) 会议论文 OAI收割 4th International Symposium on Advanced Optical Manufacturing and Testing Technologies: Optical Test and Measurement Technology and Equipment, November 19, 2008 - November 21, 2008, Chengdu, China Cai X.; Zhai L. P. 收藏 \| 浏览/下载：57/0 \| 提交时间：2013/03/25 In current field of CCD measurement large area and high resolution CCD is used to obtain big measurement image so that speed and capacity of CCD requires high performance of later storage and process system. The paper discusses how to use SCSI hard disk to construct storage system and use DSPs and FPGA to realize image compression. As for storage subsystem Because CCD is divided into multiplex output SCSI array is used in RAID0 way. The storage system is composed of high speed buffer DMA controller control MCU SCSI protocol controller and SCSI hard disk. As for compression subsystem according to requirement of communication and monitor system the output is fixed resolution image and analog PAL signal. The compression means is JPEG2000 standard in which 9/7 wavelets in lifting format is used. 2 DSPs and FPGA are used to compose parallel compression system. The system is composed of FPGA pre-processing module DSP compression module video decoder module data buffer module and communication module. Firstly discrete wavelet transform and quantization is realized in FPGA. Secondly entropy coding and stream adaption is realized in DSPs. Last analog PAL signal is output by Video decoder. Data buffer is realized in synchronous dual-port RAM and state of subsystem is transfer to controller. Through subjective and objective evaluation the storage and compression system satisfies the requirement of system. 2009 SPIE.
	A high-speed image sensing technique with adjustable frame rate based on an ordinary CCD 期刊论文 OAI收割 optik, 2008, 卷号: 119, 期号: 11, 页码: 548, 552 He Guotian; 王向朝; Li Dailin; Hu Jianmin 收藏 \| 浏览/下载：1087/176 \| 提交时间：2009/09/18 high-speed image sensor area array CCD driving circuit frame rate signal processing
	Data preprocessing of the exterior field of vision assembling photogrammetric camera (EI CONFERENCE) 会议论文 OAI收割 3rd International Symposium on Advanced Optical Manufacturing and Testing Technologies: Optical Test and Measurement Technology and Equipment, July 8, 2007 - July 12, 2007, Chengdu, China 作者: Li J.; Li J.; Li J.; Liu J.; Liu J. 收藏 \| 浏览/下载：78/0 \| 提交时间：2013/03/25 Transmit array photogrammetric camera can obtain image which is high geometric fidelity and high photogrammetric quality. However the single chip array CCD image sensor camera can't meet the need of measuring precision and photogrammetric covering area. In order to obtain large numbers of information and extensive photogrammetric covering area we must increase field of vision angle and improve photogrammetric covering area. And all these objects can be realized by exterior field of vision assembling photogrammetric camera. Two side work must be done before images which obtained by exterior field of vision assembling photogrammetric camera be used in photogrammetry. First all assembling camera focal plane need be converted to a benchmark coordinate focal plane to realize camera digital assembling. Second images must be re-sampled and processing. Because of coordinate conversion two images from different assembling cameras can be established function relation which a pixel of image from a camera is corresponding to a pixel of another image from different camera. But through this conversion some pixels maybe extrusion together and other pixels separate on an image area. So interpolation direction finding(IDF) is used to obtain these pixels and realize image re-sampling. In this paper the structure of exterior field of vision assembling photogrammetric camera is analyzed and the coordinate conversion method of exterior field of vision assembling photogrammetric camera and image gray re-sampling method also can be discussed. All the works are based to data pretreatment of exterior vision assembling photogrammetric camera.
	A novel airborne digital camera system - art. no. 620007 会议论文 OAI收割 Remote Sensing of the Environment: 15th National Symposium on Remote Sensing of China, Bellingham Fang, Junyong; Liu, Xue; Wei, Zheng; Zhang, Bing; Zheng, Lanfen; Tong, Qingxi 收藏 \| 浏览/下载：30/0 \| 提交时间：2014/12/07 airborne remote sensing area array CCD digital camera multi-mode wide field multi-spectral stereo imaging POS aerial experiments