Pneumatic pump chip by 3D printing technology
文献类型：会议论文
| 作者 | Wang JY(王敬依) ; Yao P(姚萍); Jiao ND(焦念东); Tung, Steve; Liu LQ(刘连庆)
|
| 出版日期 | 2015 |
| 会议名称 | 5th International Conference on Manipulation, Manufacturing and Measurement on the Nanoscale, 3M-NANO 2015 |
| 会议日期 | October 5-9, 2015 |
| 会议地点 | Changchun, China |
| 关键词 | 3D printing pump microfluidic chip pneumatic actuation flow rate time and cost saving |
| 页码 | 240-244 |
| 中文摘要 | This paper presents a new method of microfluidic chip fabrication using 3D design and 3D printing techniques. The printed materials are flexible and inexpensive. The fabrication procedure is time-saving and less complex. The water leakage and hydrophilic test are performed to prove the advantages over traditional methods. The flow rates of the printed pump chip have been tested under varied applied pneumatic pressures and pumping frequencies. A maximal flow rate of 16.08 μL/min is achieved at the driving frequency of about 10 Hz at pressure of 30 psi. And a maximal flow rate of 38.60 μL/min is achieved at the driving frequency of about 10 Hz at pressure of 40 psi.IEEE. |
| 收录类别 | EI ; CPCI（ISTP） |
| 产权排序 | 1 |
| 会议录 | 5th International Conference on Manipulation, Manufacturing and Measurement on the Nanoscale, 3M-NANO 2015 - Conference Proceedings
 |
| 会议录出版者 | IEEE |
| 会议录出版地 | Piscataway, NJ, USA |
| 语种 | 英语 |
| ISSN号 | 2373-5422 |
| ISBN号 | 978-1-4673-9625-7 |
| WOS记录号 | WOS:000380540600004 |
| 源URL | [http://ir.sia.cn/handle/173321/18620]  |
| 专题 | 沈阳自动化研究所_机器人学研究室 |
| 推荐引用方式 GB/T 7714 | Wang JY,Yao P,Jiao ND,et al. Pneumatic pump chip by 3D printing technology[C]. 见:5th International Conference on Manipulation, Manufacturing and Measurement on the Nanoscale, 3M-NANO 2015. Changchun, China. October 5-9, 2015. |
入库方式： OAI收割
来源：沈阳自动化研究所
浏览0
下载0
收藏0
其他版本
除非特别说明，本系统中所有内容都受版权保护，并保留所有权利。