中国科学院机构知识库网格系统: 检索

浏览/检索结果: 共9条，第1-9条

帮助

条数/页：排序方式：
	Neural Network Based Aliasing Spectral Decoupling Algorithm for Precise Mid-Infrared Multicomponent Gases Sensing 期刊论文 OAI收割 ACS SENSORS, 2024 作者: Xiong, Hao; Shao, Ligang; Cao, Yuan; Wang, Guishi; Wang, Ruifeng \| 收藏 \| 浏览/下载：6/0 \| 提交时间：2024/11/20 neural networks midinfrared multicomponent gases sensor aliasing spectral cross-interference wavelength modulationspectroscopy synchronous measurement
	A Dynamic Decoupling Control Method for PMSM of Brake-by-Wire System Based on Parameters Estimation 期刊论文 OAI收割 IEEE-ASME TRANSACTIONS ON MECHATRONICS, 2021 作者: Zhu, Zheng; Wang, Xiangyu; Yan, Bingjie; Li, Liang; Wu, Qiong \| 收藏 \| 浏览/下载：61/0 \| 提交时间：2022/01/25 Inductance Vehicle dynamics Permanent magnet motors Synchronous motors Inductance measurement Stator windings Couplings Brake-by-wire (BBW) dynamic decoupling permanent magnet synchronous motor (PMSM) recursive least square (RLS) thermodynamic model
	Design and calibration of the solar irradiance monitor (EI CONFERENCE) 会议论文 OAI收割 International Symposium on Photoelectronic Detection and Imaging 2011: Space Exploration Technologies and Applications, May 24, 2011 - May 26, 2011, Beijing, China 作者: Yang D.-J.; Gong C.-H.; Wang Y.-P.; Ye X.; Fang W. 收藏 \| 浏览/下载：26/0 \| 提交时间：2013/03/25 The solar irradiance monitor (SIM) with the design accuracy of 5 used to monitor the secular changes of the total solar irradiance on FY-3 satellite takes the sun-scanning measurement method on-orbit. Compared to the sun-tracking measurement method this method simplifies the structure and cuts the cost but the measuring accuracy is affected by the sun-synchronous orbit sunlight incidence angle and the installing angle of the SIM in the satellite. Through the ground calibration experiment studies on the affection of different sunlight incidence angles to the measurement accuracy. First by the satellite tool kit (STK) simulation software simulates the orbital parameters of the sun-synchronous satellite and calculates the Sun ascension and declination at any time. By the orbit coordinate transformation matrix gets the components of the Sun vectors to the axes of the satellite and base on the components designs the field of view and the installing angles of the SIM. Then designs and completes the calibration experiment to calibrate the affection of the incidence angles. Selecting 11 different angles between the sunlight and the satellite X-axis measures the total solar irradiance by the SIM at each angle and compares to the irradiances of the SIAR reference radiometers and gets the coefficient curves of the three channels of the SIM. Finally by the quadratic fitting gets the correction equations on the incidence angles: R 1=5.7110-52 -2.45310 -3+1.0302 R2=2.8410-5-1. 96510-3+1.0314 and R3 =1.7210 -52-4.18410-4+0.9946. The equations will aimprove the on-orbit measurement accuracy of the solar irradiance and are very important to the on-orbit data processing after the satellite launched. 2011 SPIE.
	An X-ray spectroscopy system and its application to the laser-Compton scattering experiments 期刊论文 OAI收割 NUCLEAR INSTRUMENTS & METHODS IN PHYSICS RESEARCH SECTION A-ACCELERATORS SPECTROMETERS DETECTORS AND ASSOCIATED EQUIPMENT, 2010, 卷号: 624, 期号: 1, 页码: 7 Luo, W.（罗文）; Xu, W.（徐望）; Pan, Q. Y.（潘强岩）; Fan, G. T.（范功涛); Fan, G. W.（樊广伟）; Li, Y. J.; Xu, B. J.(徐本基); Xu, Y.（徐毅）; Yan, Z.（阎喆）; Yang, L. F.（杨利峰）收藏 \| 浏览/下载：38/0 \| 提交时间：2012/04/11 Si(Li) detector Data acquisition (DAQ) Laser Compton scattering (LCS) Synchronous measurement
	Electro-optical sampling non-synchronous delay scanning measurement of electron beam bunch length at BFEL 期刊论文 OAI收割 CHINESE PHYSICS C, 2010, 卷号: 34, 期号: 2, 页码: #REF! 作者: Sun DR(孙大睿); Xu JQ(徐金强); Chen SY(陈森玉); Sun, DR; Xu, JQ 收藏 \| 浏览/下载：55/0 \| 提交时间：2016/04/12 electro-optical sampling measurement of electron beam bunch length non-synchronous delay scanning technique
	Electro-optical sampling non-synchronous delay scanning measurement of electron beam bunch length at BFEL 期刊论文 OAI收割中国物理C, 2010, 期号: 2, 页码: 227-230 作者: Sun DR(孙大睿); Xu JQ(徐金强); Chen SY(陈森玉) 收藏 \| 浏览/下载：57/0 \| 提交时间：2015/12/07 electro-optical sampling measurement of electron beam bunch length non-synchronous delay scanning technique
	Storage and compression design of high speed CCD (EI CONFERENCE) 会议论文 OAI收割 4th International Symposium on Advanced Optical Manufacturing and Testing Technologies: Optical Test and Measurement Technology and Equipment, November 19, 2008 - November 21, 2008, Chengdu, China Cai X.; Zhai L. P. 收藏 \| 浏览/下载：57/0 \| 提交时间：2013/03/25 In current field of CCD measurement large area and high resolution CCD is used to obtain big measurement image so that speed and capacity of CCD requires high performance of later storage and process system. The paper discusses how to use SCSI hard disk to construct storage system and use DSPs and FPGA to realize image compression. As for storage subsystem Because CCD is divided into multiplex output SCSI array is used in RAID0 way. The storage system is composed of high speed buffer DMA controller control MCU SCSI protocol controller and SCSI hard disk. As for compression subsystem according to requirement of communication and monitor system the output is fixed resolution image and analog PAL signal. The compression means is JPEG2000 standard in which 9/7 wavelets in lifting format is used. 2 DSPs and FPGA are used to compose parallel compression system. The system is composed of FPGA pre-processing module DSP compression module video decoder module data buffer module and communication module. Firstly discrete wavelet transform and quantization is realized in FPGA. Secondly entropy coding and stream adaption is realized in DSPs. Last analog PAL signal is output by Video decoder. Data buffer is realized in synchronous dual-port RAM and state of subsystem is transfer to controller. Through subjective and objective evaluation the storage and compression system satisfies the requirement of system. 2009 SPIE.
	The Simulation measurement experiment and calibration for Solar Total Irradiance Monitor on board (EI CONFERENCE) 会议论文 OAI收割 ICO20: Remote Sensing and Infrared Devices and Systems, August 21, 2005 - August 26, 2005, Changchun, China Yupeng W.; Wei F.; Bingxi Y. 收藏 \| 浏览/下载：37/0 \| 提交时间：2013/03/25 STIM (Solar Total Irradiance Monitor) can be used on sun-synchronous polar orbit weather satellites to measure the total solar irradiance. It contains three independent and identical wide view absolute radiometers. They are mounted on the satellite in an angle which ensure the sun scan over the field of view of the absolute radiometers. This measurement method doesn't need the instrument tracking the sun but the sun scan over the field of view of the absolute radiometers in each orbit cycle. The paper presents the measurement method of simulation for solar irradiance measurement and calibration by mounting the instrument on a two-axis rotation table. By controlling the rotation angle velocity of the instrument in the meridian direction being the same as that of the weather satellite's on orbit we can measure the solar irradiance when the sun scan over the field of view of the absolute radiometers to simulate the onboard state. And we have operated the measurement with the prototype of STIM. The SIAR-1 is traceable to WRR and serves as a transfer standard. So simultaneous comparison measurements between SIAR-1 and each of the three wide view absolute radiometers are measured to provide calibration corrections to the instrument. And we have a further study at the influence of stray light to the measurement results. This paper presents the method of simulation experiment and calibration for solar irradiance measurement with Solar Total Irradiance Monitor on board.
	The full hemisphere integrating measurement of the reflectance of black cavity (EI CONFERENCE) 会议论文 OAI收割 ICO20: Illumination, Radiation, and Color Technologies, August 21, 2005 - August 26, 2005, Changchun, China 作者: Wang Y.; Yu B.; Wang Y.; Wang Y.; Wang Y. 收藏 \| 浏览/下载：18/0 \| 提交时间：2013/03/25 The conical black cavities are used in the Solar Irradiance Absolute Radiometers (SIARs) of the solar constant monitor aboard on the SZ spaceship and of the Solar Total Irradiance Monitor (STIM) aboard on sun-synchronous polar orbit weather satellites. A low reflectance measurement instrument which is used for making the integrating measurement on the reflectance of the conical black cavity in a high precision within the full hemisphere (include the entrance of the Ulbrichtsphere) has been constructed. The characteristic of the instrument is the employment of a semi-transparent mirror which is mounted in an inclination angle of 45 degrees in front of the entrance of the Ulbrichtsphere. The incident beam is reflected to the black cavity or white board by the semi-transparent mirror. A portion of those which is made diffused reflection through the black cavity or white board is measured by the detector located in the side face of the Ulbrichtsphere and the other portion which is reflected to the entrance is measured by the other detector after passing through the semi-transparent mirror and then being focused on by an ellipsoidal mirror. The two measurement data are added up to get the integrating reflectance within full hemisphere. The presentation and verification on the measurement result of the reflectance of the black cavity and its precision are described in this article. The absolute accuracy can reach 0.012%.